QUESTION: 105

"The network administrator created VLAN 10 on the Layer 3 switch and configured an IP address under the virtual interface of the VLAN. When using the command "display ip interface brief to view the port status, and found that the VLANIF10 interface is in the dow state, what should be done? Operation to restore the VLANIF10 interface to normal? ()

Assign an interface that must be Up and must be of type Trunk into VLAN 10
Assign any physical interface to VLAN10
Assign a physical interface that must be Up to VLAN 10
Use the command "undo shutdown" under the VLANIF10 interface

Answer(s): D

Reveal Solution Next Question

QUESTION: 106

The configuration information of a certain port of the switch is shown in the figure. Which of the following statements is wrong? ()
interface GigabitEthernet0/0/1 port link type trunk port trunk pviD.vlan 200 port trunk allow-pass vlan100#

If the VLAN TAG carried in the data frame is 100, the switch will strip off the VLAN TAG and send it out
This port cannot send data frames carrying VLAN TAG200
The port type is Trunk type
If the port receives a data frame without VLAN TAG, the switch needs to add VLAN TAG 200

Answer(s): A

Reveal Solution Next Question

QUESTION: 107

AAA. Which of the following is not included? ()

Authentication
Accounting
Authorization
Audit

Answer(s): D

Reveal Solution Next Question

QUESTION: 108

Which of the following statements about Prefix Segment is wrong? ()

Prefix Segment spreads to other network elements through the IGP protocol, which is globally visible and effective
Prefix Segment needs to be configured manually
Prefix Segment is used to identify a destination address prefix in the network (Prefix)
Prefix Segment can be automatically allocated by IGP

Answer(s): D

Reveal Solution Next Question

Free H12-811 Exam Braindumps (page: 27)

QUESTION: 105

QUESTION: 106

QUESTION: 107

QUESTION: 108