QUESTION: 9

In the figure below, all switches have enabled the STP protocol, assuming that the path cost value of all ports is 200. What is the root path cost value contained in the configuration BPDU message received by the G0/0/4 port of $WD? () (Single-choice question)

Answer(s): D

Reveal Solution Next Question

QUESTION: 10

The information shown in the figure is the port status information displayed on a switch running STP. According to this information, what is wrong in the following description? () (Single-choice question)

This switch is the root switch in the network
The priority of this switch is 0
This network may only contain this switch
This switch may be connected to 6 other switches

Answer(s): B

Reveal Solution Next Question

QUESTION: 11

As shown in the figure, the switch runs STP with default parameters. Which of the following ports will be elected as the designated port? () (Single-choice question)

Port G0/0/1 of switch A
HUB's G0/0/1 port
HUB's G0/0/2 port
Port G0/0/2 of switch A

Answer(s): A

Reveal Solution Next Question

QUESTION: 12

As shown in the figure below, all hosts can communicate normally. Is the correspondence between the MAC address and the port in the MAC address table of SWB correct? () (Single-choice question)

MAC-A GO/0/1
MAC-B GO/0/2
MAC-C GO/0/3
MAC-A GO/0/2
MAC-B G0/0/2
MAC-C GO/0/3
MAC-A GO/0/3
MAC-B GO/0/3
MAC-C GO/0/1
MAC-A GO/0/1
MAC-B GO/0/1
MAC-C GO/0/3

Answer(s): C

Reveal Solution Next Question

Free H12-811 Exam Braindumps (page: 3)

QUESTION: 9

QUESTION: 10

QUESTION: 11

QUESTION: 12