QUESTION: 137

The following description of the attributes of BGP is correct? Radio

The AS number of the adjacent AS, ranked to the far right of the list of AS_Path in the BGP route entry.
When a BGP Speaker publishes a route learned from an EBCP peer to an IBGP peer, it does not change the next hop attribute of that routing information.
Local_Pref is valid only between EBGP peers and is not advertised to third-party AS
A route can have only one community attribute value.

Answer(s): B

Reveal Solution Next Question

QUESTION: 138

The following description of BGP load sharing is wrong with ?( Multiple choice question)

The AS_Path properties of the equivalent routes that form load sharing must be different.
The destination CIDR blocks are the same, and load sharing can be formed between BGP routes with different sources.
If BGP load sharing is implemented , the local device needs to configure the peer next- hop-local command to change the next hop address to its own address when issuing a route to an IBGP peer group .
IBGP routes and EBGP routes that reach the same destination in the public network can form a load sharing

Answer(s): A,B,C,D

Reveal Solution Next Question

QUESTION: 139

The main routing policy tools that BGP can use are Filter-policy and Route-policy, where Fate-policy can only filter routes and Route-policy can only modify routes

TRUE
FALSE

Answer(s): B

Reveal Solution Next Question

As shown in the figure, the use of redundant links between the branch and the headquarters to establish IPsecVPN, while turning on URLPF on the Router_B for traffic from branch l, which of the following options is correct?

When using IPsec active-standby link redundant backups to enable the URPF function under the physical interface , it is recommended to use URPF loose mode.
When using IPsec multilink redundant backup, the URPF function can be used under the physical interface, and URPF strict mode can be used
When using IPsec multilink redundant backups, urPF can be enabled under the tunnel interface, and URPF strict mode can be used
When using lPsec active-standby link redundancy backup, the URPF function is enabled under the physical interface, and URPF strict mode can be used.

Answer(s): A,C

Reveal Solution Next Question

Free H12-891_V1.0 Exam Braindumps (page: 35)

QUESTION: 137

QUESTION: 138

QUESTION: 139

QUESTION: 140