QUESTION: 41

Regarding the description of the design principles of Locator SID, it is incorrect ()

For the Locator CIDR block planning of SRv6, the appropriate mask should be set according to the number of IPv6 SIDs that may be used by the device.
loatos svV6_locator ipu6-prelix21. DB8ABCD: .b4 static 32, Locator is 2001.DB8.ABCD:, length 64 bits, static segment occupies 32 bits, dynamic segment occupies 32 bits args field occupies O bits.
The starting value of the state segment is: 2001:DB8:ABCD:0000:0000:0000:C
Locator SID supports static configuration or dynamic allocation, end-op and end-m must be statically configured, and static configuration is also recommended for end and end.x, which is convenient for network O&M. Other SIDs can be assigned dynamically.
Devices at the same site belong to the same large network segment with the same prefix, and different devices are assigned to the small network segment with the same prefix in the large network segment.

Answer(s): B

Reveal Solution Next Question

QUESTION: 42

Regarding the behavior of END, the wrong statement is ()

end. DT4: EVPN VPLS unicast meteor
end.dx2: the L2AC interface used to divert traffic to the egress PE
end. X SID: A link used to direct traffic to a specific node
end SID: Redirects traffic to nodes based on the IP routing table

Answer(s): A

Reveal Solution Next Question

QUESTION: 43

The source of policy generation does not include ()

IGP
CLI/Netconf/yang
BGP
PCEP

Answer(s): A

Reveal Solution Next Question

In the southbound protocol of the controller, the () protocol is the LSP communication protocol between the NCE and the PCC, the PCC reports LSP status information to the NCE, and the NCE notifies the PCC to update the tunnel LSP.

PCEP
Netconf
BGP-LS
SNMP

Answer(s): A

Reveal Solution Next Question

Free H19-424_V1.0 Exam Braindumps (page: 12)

QUESTION: 41

QUESTION: 42

QUESTION: 43

QUESTION: 44

H19-424_V1.0 Discussions & Posts