Free JN0-1330 Exam Braindumps
Security Design Questions 21–25 (page: 6)

Updated On: 10-Feb-2026

What is one way to increase the security of a site-to-site IPsec VPN tunnel?

  1. Implement a stronger Diffie-Hellman group.
  2. Change IKE Phase 1 from main mode to aggressive mode.
  3. Implement traffic selectors.
  4. Implement a policy-based VPN.

Answer(s): C



Your customer is planning the deployment of a new hub-and-spoke WAN architecture that must support dual stack They have decided against using a dynamic routing protocol. They are concerned about the difficulty of managing configurations and operations at the hub location as they deploy branch routers
In this scenario, what ate three reasons for selecting route-based VPNs with traffic selectors'? (Choose three)

  1. Traffic selectors support IPv4 and IPv6.
  2. Traffic selectors reduce the number of Phase 2 IPsec security associations.
  3. Traffic selectors reduce latency because they bypass UTM.
  4. Traffic selectors support auto route insertion
  5. You can define mutliple traffic selectors within a single route-based VPN

Answer(s): A,D,E



What are the three activities in the reconnaissance phase of an attack"? (Choose three)

  1. Determine the device OS
  2. Scan for devices and ports to exploit
  3. Install malware.
  4. Propagate the virus to servers and workstations
  5. Map the network

Answer(s): A,B,E



Your customer is assessing (heir network incident response plan They need to improve their recovery lime when a networking issue occurs, especially when involves JTAC support. They have limited internal support staff and little automation experience to develop their own tools Which Juniper solution meets these requirements'?

  1. Juniper Secure Analytics
  2. Network Director
  3. Service Insight
  4. Service Now

Answer(s): D



Your customer is planning to secure a data center with web servers reachable through two ISP connections terminating on each node of an active/passive SRX Series chassis cluster. ISP-1 Is the preferred connection because it provides higher bandwidth than ISP-2.
Which two must you include in your design proposal to meet this requirement (Choose two)

  1. Use conditional BGP advertisements and use Interface monitoring for both ISP Interfaces.
  2. Use static routing and use interface monitoring for both ISP interfaces.
  3. Ensure that both ISP interfaces are in the same zone and use interface monitoring.
  4. Ensure that both the ISP interfaces are in different zones and use interface monitoring.

Answer(s): A,D



Viewing page 6 of 14
Viewing questions 26 - 30 out of 65 questions


Post your Comments and Discuss Juniper JN0-1330 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!