CompTIA
Checkpoint
ISC
HP
Dell
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
Certiport
ISC2
All Vendors
  2. Home
  3. Exams
  4. Juniper
  5. JN0-362

Free JN0-362 Exam Braindumps (page: 5)

Page 4 of 17
PDF with 64 Questions

Click the Exhibit button.


You have configured IPv6 over IPv4 tunneling, as shown in the exhibit. However, hosts connected to network 2001:0:0:1::0/64 cannot communicate with hosts on network 2001:0:0:2::0/64. The router R2 has a similar configuration as the R1 router.

How would you solve this problem?

  1. Configure an IGP across the tunnel interfaces
  2. Configure an IPv6 address on the tunnel interfaces
  3. Configure the next hop of the inet6.0 static route to point to the physical interface between the routers
  4. Configure the next hop of the inet6.0 static route to point to the IPv4 address of the remote router

Answer(s): B



In a stateless IPv6 auto-configuration scenario, what is the host’s IPv6 address if the interface’s MAC address is 12:34:ab:cd:ef:56?

  1. fe80::1234:abff:fecd:ef56/64
  2. fe8::1234:abff:fecd:ef56/64
  3. fec0::1234:abff:fecd:ef56/64
  4. fe80::1234:abcd:ef56/64

Answer(s): A



Click the Exhibit button.


Referring to the exhibit, which two statements are correct? (Choose two.)

  1. The router will install the 0.0.0.0/0 route into the routing table when no BGP prefixes are present
  2. The router will remove the 0.0.0.0/0 route from the routing table when no BGP prefixes are present
  3. The router will remove the 0.0.0.0/0 route from the routing table when any BGP prefixes are present
  4. The router will install the 0.0.0.0/0 route into the routing table when any BGP prefixes are present

Answer(s): B,D



Click the Exhibit button.


Both configuration hierarchies shown in the exhibit have been committed to your MX Series device. Which two statements are true in this scenario? (Choose two.)

  1. Traffic destined to 10.3.0.1 will use the R1-to-R6 LSP as a next hop
  2. Traffic destined to 10.3.0.1 will not use the R1-to-R6 LSP as a next hop
  3. The active 10.3.0.0/24 prefix installed in the route table will have a route preference of 5
  4. The active 10.3.0.0/24 prefix installed in the route table will have a route preference of 7

Answer(s): A,D






Post your Comments and Discuss Juniper JN0-362 exam with other Community members:

JN0-362 Discussions & Posts