CompTIA
Checkpoint
ISC
HP
Dell
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
Certiport
ISC2
All Vendors
  2. Home
  3. Exams
  4. Network Appliance
  5. NS0-520

Free NS0-520 Exam Braindumps (page: 33)

Page 33 of 59
PDF with 234 Questions

Which two components must be verified for a supported NetApp SAN confutation? (Choose two.)

  1. host memory
  2. host GPU
  3. host multipath
  4. host bus adapter

Answer(s): C,D



You want to access and mount a Linux L.UN using only iSCSl. In the past, the LUN ha;; been accessed using FC. What must you do to accomplish this task?

  1. Change the LUN protocol type to (SCSI.
  2. Create a new iSCSI igroup. and change the LUN mapping from the original to the new igroup.
  3. Create a new iSCSI Igroup and map the LUN to both the new and existing FC igroup.
  4. Add an iSCSI protocol type to the existing igroup so that the LUN can be accessed by both FC and iSCSI hosts.

Answer(s): B



Exhibit.



You want to configure a UTA2 port as an FCoE target. Referring to the exhibit, which action must be performed?

  1. Configure the port mode as CN
  2. Configure the port mode as Ethernet.
  3. Configure the port type as initiator.
  4. Configure the port mode as FC.

Answer(s): A



You are planning few a new AFF A700 2-node switchless FC solution with two Cisco 9100 switches. Each AFF A700 will have one 16 Gb port Connected to each Cisco 9100 switch and four FC LIKs per physical port. You want to guarantee recovery from connection loss on a NetApp physical port and you are using single initiator to multiple target zoning.
What is the minimum number of zones required to accomplish this task?

  1. 8
  2. 4
  3. 2
  4. 1

Answer(s): C



Page 33 of 59



Post your Comments and Discuss Network Appliance NS0-520 exam with other Community members:

Raphael commented on April 17, 2024
I studied for 3 weeks after I bought the full PDF exam dump. That was enough for me to pass my exam.
FINLAND
upvote