Reference: Oracle Solaris Administration: Network Interfaces and NetworkVirtualization,
Activating and Deactivating Profiles
Reference: Oracle Solaris Administration: Network Interfaces and
NetworkVirtualization,Creating and Managing Locations
QUESTION: 13
On server A, you enter the following command to add a static route to serverA
route -p add -host 192.168.1.101 192.168.1.101 -static

What is the purpose of this command?

A. to temporarily bypass IP Filter rules
B. to specify an IPMP target IP address to in.mpathd
C. to specify routing to an adjacent network when in.rdisc is not used
D. to specify routing to an adjacent network when in.routed is not used
E. to ensure the IP address for serverB is not flushed from the ARP cache
F. to optimize link aggregation using a direct connection between two systems

Answer(s): B

Note: # route -p add -host destination-IP gateway-IP -static
where destination-IP and gateway-IP are IPv4 addresses of the host to be used as a target.

For example, you would type the following to specify the target system 192.168.10.137, which is
on the same subnet as the interfaces in IPMP group itops0:

$ route -p add -host 192.168.10.137 192.168.10.137 -static
This new route wil be automatically configured every time the system is restarted. If you want to
define only a temporary route to a target system for probe-based failure detection, then do not
use the -p option.
QUESTION: 14
Before booting test zone a non-global zone, you want to connect to the zone's console so that
you can watch the boot process. Choose the command used to connect to testzone's console.

A. zoneadm -C testzone
B. zoneadm -console testzone
C. zlogin - z testzone console
D. zlogin - z testzone - C
E. zlogin -C testzone
F. zoneadm - testzone - c

Free Oracle 1Z0-820 Exam Braindumps (page: 21)

1Z0-820 Exam Discussions & Posts