QUESTION: 193

Refer to the exhibit.

In the exhibit, Client41 and Client42 have full access to the HTTP and FTP services provided by Server31 and Server32 respectively. They continue to have access to these servers after SH3 and SH4 are deployed. A quick check on SH3 and SH4 registers the connections from Client41 and Client 42 as pass-through traffic. Note that SH3 and SH4 are in auto-discovery mode. What are the likely causes? (Select 2)

Pass-through rules are specified in the Steelhead appliances to bypass TCP traffic from Client41 and Client42
Deny rules are specified in the Steelhead appliances to bypass IP traffic from Client41 and Client42
There is a firewall inside the WAN cloud which strips the TCP options field
There is a firewall inside the WAN cloud which strips the IP options field

Answer(s): A,C

Reveal Solution Next Question

QUESTION: 194

Where in the Steelhead appliance can you verify IP address settings? (Select 2)

Interface Statistics
View the configuration
Neighbor Statistics
QoS Statistics
Log messages

Answer(s): A,B

Reveal Solution Next Question

QUESTION: 195

In a new in-path deployment, connections are listed as pass-through on the branch office Steelhead appliance. Which of the following is the likely cause of the problem?

1) Pass-through rule preventing optimization
2) Server-side Steelhead appliance is down
3) Satellite proxy not copying auto-discovery probes
4) Asymmetric routing is detected for the client/server flow
5) Duplex mismatch on WAN or LAN interface

3, 2
2, 4
1, 2, 5
1, 2, 3, 4
1, 2, 3, 4, 5

Answer(s): D

Reveal Solution Next Question

QUESTION: 196

You are troubleshooting a new Steelhead Mobile installation where none of the VPN users with Steelhead Mobile client installed are being optimized. You determine that the Steelhead appliance in the data center is not in-path for VPN users. What are your options to fix this? (Select 2)

Use the Steelhead in an out-of-path deployment using fixed-target rules in the Steelhead appliance
Use the Steelhead in a hybrid in-path/out-of-path deployment using fixed-target rules in the Steelhead Mobile client
Put the Steelhead appliance in-path on the VPN concentrator segment using a multi-port NIC
Install the Steelhead Mobile Controller on the VPN segment

Answer(s): B,C

Reveal Solution Next Question

Free 830-01 Exam Braindumps (page: 49)

QUESTION: 193

QUESTION: 194

QUESTION: 195

QUESTION: 196