CompTIA
Checkpoint
ISC
HP
Dell
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
Certiport
ISC2
All Vendors
  2. Home
  3. Exams
  4. Riverbed
  5. 830-01

Free 830-01 Exam Braindumps (page: 50)

Page 49 of 101
PDF with 402 Questions

Refer to the exhibit.


In the exhibit, Client41 and Client42 have full access to the HTTP and FTP services provided by Server31 and Server32 respectively. They continue to have access to these servers after SH3 and SH4 are deployed. A quick check on SH3 and SH4 registers the connections from Client41 and Client 42 as pass-through traffic. Note that SH3 and SH4 are in auto-discovery mode. What are the likely causes? (Select 2)

  1. Pass-through rules are specified in the Steelhead appliances to bypass TCP traffic from Client41 and Client42
  2. Deny rules are specified in the Steelhead appliances to bypass IP traffic from Client41 and Client42
  3. There is a firewall inside the WAN cloud which strips the TCP options field
  4. There is a firewall inside the WAN cloud which strips the IP options field

Answer(s): A,C



Where in the Steelhead appliance can you verify IP address settings? (Select 2)

  1. Interface Statistics
  2. View the configuration
  3. Neighbor Statistics
  4. QoS Statistics
  5. Log messages

Answer(s): A,B



In a new in-path deployment, connections are listed as pass-through on the branch office Steelhead appliance. Which of the following is the likely cause of the problem?

1) Pass-through rule preventing optimization
2) Server-side Steelhead appliance is down
3) Satellite proxy not copying auto-discovery probes
4) Asymmetric routing is detected for the client/server flow
5) Duplex mismatch on WAN or LAN interface

  1. 3, 2
  2. 2, 4
  3. 1, 2, 5
  4. 1, 2, 3, 4
  5. 1, 2, 3, 4, 5

Answer(s): D



You are troubleshooting a new Steelhead Mobile installation where none of the VPN users with Steelhead Mobile client installed are being optimized. You determine that the Steelhead appliance in the data center is not in-path for VPN users. What are your options to fix this? (Select 2)

  1. Use the Steelhead in an out-of-path deployment using fixed-target rules in the Steelhead appliance
  2. Use the Steelhead in a hybrid in-path/out-of-path deployment using fixed-target rules in the Steelhead Mobile client
  3. Put the Steelhead appliance in-path on the VPN concentrator segment using a multi-port NIC
  4. Install the Steelhead Mobile Controller on the VPN segment

Answer(s): B,C






Post your Comments and Discuss Riverbed 830-01 exam with other Community members:

830-01 Discussions & Posts