QUESTION: 9

Which two of the following troubleshooting steps can be performed when a node is "up" and the data cannot be found in SolarWinds' platform web console? (Choose two.)

Add a remote site node and make sure the firewall rules are configured to allow SNMP traffic.
Ping the device from the polling engine the device is assigned to using the command line.
Verify hardware health sensors on the device provide both status and values.
Wait ten minutes after a device is added to the console. Refresh the screen.

Answer(s): B,D

Reveal Solution Next Question

QUESTION: 10

Which tool can be used to display the physical layout of interfaces on graphical stencils?

device studio
device view
NetPath
network insight

Answer(s): B

Reveal Solution Next Question

QUESTION: 11

Which two of the following best practices are used when creating a universal device poller (UDP)? (Choose two.)

Call SolarWinds support for object ID (OID) options.
Consult vendor documentation for OID.
Perform SNMPwalk to determine if OID exists.
Run WBemtest to test communication to OI

Answer(s): B,C

Reveal Solution Next Question

QUESTION: 12

A poller is to be built that will add two values together to show a single value in the web console using the universal device poller (UDP) tool. How would this be accomplished?

add both object IDs (OIDs) to the poller and combine values in a single value for the web console
build a poller for each OID then use transform results to combine values from the two pollers
UDP tool does not support more than one OID per poller, another OID is needed
UDP tool does not support more than one OID per poller, another tool is needed

Answer(s): B

Reveal Solution Next Question

Free Hybrid Cloud Observability Network Monitoring Exam Braindumps (page: 4)

QUESTION: 9

QUESTION: 10

QUESTION: 11

QUESTION: 12

Hybrid Cloud Observability Network Monitoring Discussions & Posts