QUESTION: 9

Consider the following:
In Phase A a business capability map and a core set of value streams were created while developing the Architecture Vision.
Why would such Architecture Descriptions need to be updated in Phase B?

Phase B requires that all Architecture Descriptions be updated.
The development of Business Architecture Descriptions is always iterative.
Phase B is an ADM Architecture Development phase.
A new value stream was assessed as in the project scope.

Answer(s): B

Explanation:

The development of Business Architecture Descriptions is always iterative because it involves constant refinement and validation of the architecture models and views based on stakeholder feedback and changing requirements. Therefore, any Architecture Description that was created in Phase A may need to be updated in Phase B as new information or insights emerge. Phase B does not require that all Architecture Descriptions be updated, only those that are relevant and necessary for the Business Architecture. Phase B is an ADM Architecture Development phase, but that does not explain why Architecture Descriptions need to be updated. A new value stream may or may not require updating existing Architecture Descriptions depending on its scope and impact.

Reveal Solution Next Question

QUESTION: 10

What is defined as the effect of uncertainty on objectives?

Threat
Continuity
Risk
Vulnerability

Answer(s): C

Explanation:

Risk is defined as the effect of uncertainty on objectives. It can be positive or negative depending on whether it enhances or hinders the achievement of objectives. Threat is a potential cause of risk that could have a negative impact on objectives. Continuity is the ability to maintain or resume normal operations after a disruption or disaster. Vulnerability is a weakness or exposure that could be exploited by a threat to cause harm or damage.

Reveal Solution Next Question

QUESTION: 11

Consider the following graphic illustrating a method supporting the TOGAF ADM.

What does the method help identify?

Solution Building Blocks
Business Scenarios
Alternative Target Architectures
Architecture Solutions

Answer(s): C

Explanation:

The graphic illustrates a method for developing alternative target architectures in Phase E of the TOGAF ADM1. The method involves identifying and evaluating candidate architectures based on criteria such as business value, cost, risk, and feasibility. The method helps to identify the most suitable architecture solution for the enterprise.

Reveal Solution Next Question

QUESTION: 12

Consider the following modeling example, relating business capabilities to organization units so as to highlight duplication and redundancy:

(Note in this example the cells colored green, yellow, and red, are also marked G. Y, and R, respectively) Which of the following best describes this technique?

Relationship Mapping
Capability Mapping
Perspective Analysis
Gap Analysis

Answer(s): A

Explanation:

The technique shown in the example is called relationship mapping. It is a technique that can be used to show how a business architecture addresses stakeholder concerns across different parts of an organization. It can highlight gaps or overlaps in the coverage of stakeholder concerns by a business architecture. In this case, the technique is used to relate business capabilities to organization units so as to highlight duplication and redundancy.

Reveal Solution Next Question

Free OGBA-101 Exam Braindumps (page: 3)

QUESTION: 9

Explanation:

QUESTION: 10

Explanation:

QUESTION: 11

Explanation:

QUESTION: 12

Explanation: