Free TT0-101 Exam Braindumps (page: 14)

Page 13 of 33

When troubleshooting a network, how can a technician look at the contents of ICMP messages?

  1. By using trace route
  2. By using SNMP GET PDU
  3. By using a cable analyzer
  4. By using a protocol analyzer

Answer(s): D



Which type of message is sent with the PING command?

  1. UDP
  2. CDP
  3. SNMP
  4. ICMP

Answer(s): D



Users have been reporting an inability to access the Internet.
While checking the router, the technician determines that all interfaces are in the desired state. Given this situation, which of the following steps would help identify and isolate the source of the problem?

  1. Check the router’s AC power stability with a tester.
  2. PING the router from the locations reporting failure.
  3. Initiate a trouble ticket with the WAN link provider.
  4. Swap out network devices one-by-one until the problem is resolved.

Answer(s): B



.
A customer has just installed a new hub connected by fiber-optic cable to an existing hub. The devices on the new LAN segment are not communicating with the rest of the network. The technician suspects that the fiber optic cable may be the cause.
Which of the following tools will verify that the fiber is at fault?

  1. Volt-ohm meter
  2. Bit-error rate tester
  3. Remote monitoring probe
  4. Time-Domain Reflectometer

Answer(s): D






Post your Comments and Discuss TIA TT0-101 exam with other Community members:

TT0-101 Discussions & Posts