QUESTION: 13

Where is a jitter buffer typically implemented?

At the transmitting end of the voice connection.
At the network layer 3 switch.
At the receiving end of the voice connection.
At the network layer 2 switch.

Answer(s): C

Reveal Solution Next Question

QUESTION: 14

How many analog samples occur per second during Pulse Code Modulation (PCM), as defined by the G.711 codec?

80
800
8,000
8

Answer(s): C

Reveal Solution Next Question

QUESTION: 15

Consider the following image of a Media Access Control (MAC) address: QV12116b Y$X%&*+
Which of the following describes the portion designated by letter A?

The 48 bit ID code, known as the EUI-48.
The 64 bit interface serial number, known as the known as the Organizationally Unique
Identifier (OUI).
The 48 bit ID code, known as the Mac-48.
The 24 bit vendor code, known as the Organizationally Unique Identifier (OUI)

Answer(s): D

Reveal Solution Next Question

Which of the following devices inspects incoming packets, makes dynamic routing decisions based on the source and destination IP addresses, and is considered the most appropriate device to use when forwarding packets between networks?

Gateway
Repeater
Layer 2 switch
Layer 3 switch

Answer(s): D

Reveal Solution Next Question

Free TT0-201 Exam Braindumps (page: 5)

QUESTION: 13

QUESTION: 14

QUESTION: 15

QUESTION: 16

TT0-201 Discussions & Posts