Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk
ServiceNow
All Vendors
  2. Home
  3. Exams
  4. Veritas
  5. VCS-371

Veritas VCS-371 Exam Questions
Administration of Veritas NetBackup 7.5 for Windows (Page 9 )

Updated On: 24-Feb-2026
Page 8 of 43
PDF with 207 Questions

Which two methods are used to set up disk spanning to allow backups to span multiple BasicDisk storage units? (Select two.)

  1. Select Host Properties > Media Servers > Media > Allow backups to span disks
  2. Select Storage Units > Storage Unit > Allow backup to span disks
  3. Configure a storage unit group and add all disk storage units regardless of media server
  4. Configure a storage unit group that consists only of disk storage units defined on a single media server
  5. Confirm that a load balancing storage unit is selected at the group level

Answer(s): A,D



Where should the Symantec NetBackup administrator look in the Symantec NetBackup Administration Console to determine whether an AdvancedDisk Storage server is already configured?

  1. Media and Device Management > Devices > Storage Servers
  2. Media and Device Management > Hosts > Storage Servers
  3. Media and Device Management > Credentials > Storage Servers
  4. Media and Device Management > Device Monitor > Storage Servers

Answer(s): C



A Symantec NetBackup administrator has three media servers (named prod-media, dev-media, and test-media) that are available for client backups. The administrator would like the jobs to run to the prod-media server first, unless it is down only.
How should the administrator configure the storage?

  1. Configure three storage units and then select any available in the policy
  2. Configure a storage unit group and set the storage unit selection to prioritized
  3. Configure a storage lifecycle policy and set the selection to first available
  4. Configure the storage unit group and set the storage unit selection to failover

Answer(s): D



When collecting data from assets, what is the primary factor in determining the types of data that will be collected?

  1. scope
  2. standard
  3. baseline
  4. reference asset

Answer(s): B



What must be done in order to create a new asset type?

  1. Import assets from this new type
  2. Create the asset type in the asset interface
  3. Extend the asset schema
  4. Install a new bv-Control snapin

Answer(s): C






Post your Comments and Discuss Veritas VCS-371 exam dumps with other Community members:

Join the VCS-371 Discussion