Cisco®
CompTIA
Checkpoint
ISC
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk®
Scrum
All Vendors
  2. Home
  3. Exams
  4. VMware
  5. 2V0-01.19

Free 2V0-01.19 Exam Braindumps (page: 7)

Page 6 of 17
PDF with 65 Questions

A vSphere administrator uses vMotion to migrate a virtual machine between two ESXi hosts and notices that they can no longer ping the VM. What is the cause?

  1. The destination host has an incorrect VLAN tag on the virtual machine port group for the VM.
  2. The destination host has two port groups with the same VLAN tag.
  3. There is an MTU mismatch.
  4. The virtual machine has RDMs attached.

Answer(s): B



A vSphere administrator notices that sometimes they receive poor network throughput for multiple port groups that reside on a vSwitch with multiple physical uplinks (vmnics). The configuration on the ESXi host is identical to other hosts that are working properly in the same cluster.

What should be done next?

  1. Add additional port groups the v Switch.
  2. Add additional resources to the virtual machines that are powered on.
  3. Restart Management agents in ESXi Direct Console User Interface (DCUI).
  4. Alter the failover order of the vmnics until a bad vmnic is found.

Answer(s): B


Reference:

https://docs.vmware.com/en/VMware-vSphere/6.5/com.vmware.vsphere.monitoring.doc/GUID-C4EA86FD-95CB-4DE7-A9E3-63F6BFC1A268.html



A vSphere administrator sees the alarm:
vSphere HA virtual machine failed to failover
This occurred for a number of virtual machines on a particular ESXi host in a cluster with vSphere High Availability (HA) enabled. The virtual machines guest operating systems never reported a power event. What occurred?

  1. The virtual machines were vMotioned off of the ESXi host.
  2. The ESXi host failed and vSphere HA successfully failed over the virtual machines.
  3. The previous virtual machine cloning operations failed to complete.
  4. The ESXi host is still running but has disconnected from the network.

Answer(s): B



What three steps are necessary to enable Jumbo Frames for use with an iSCSI storage array? (Choose three.)

  1. Configure the MTU on the VMKernel port.
  2. Configure the MTU on the virtual switch.
  3. Configure the MTU on the physical switch.
  4. Configure the MTU on the LAG group.
  5. Configure the MTU on the VTEP.

Answer(s): A,B,C


Reference:

https://docs.vmware.com/en/VMware-vSphere/6.7/com.vmware.vsphere.networking.doc/GUID-53F968D9-2F91-41DA-B7B2-48394D997F2A.html






Post your Comments and Discuss VMware 2V0-01.19 exam with other Community members:

Exam Discussions & Posts