QUESTION: 5

Refer to the exhibit.

Which NAT type must the NSX-T Data Center administrator create on the Tier-0 or Tier-1 Gateway to allow Web VM to initiate communication with public networks?

SNAT
Reverse NAT
DNAT
1:1 NAT

Answer(s): A

Reveal Solution Next Question

QUESTION: 6

An NSX administrator would like to configure syslog for a KVM transport node.

Which host log files could be exported to a remote syslog server?

/var/log/vmware/nsx-syslog
/var/log/cfgAgent.log
/var/log/nsx-audit.log
/var/log/cloudnet/nsx-ccp.log

Answer(s): A

Reveal Solution Next Question

QUESTION: 7

Which two ports are used by a transport node to communicate with the management and control planes in NSX-T Data Center 3.0? (Choose two.)

5685
1235
5671
5678
1234

Answer(s): B,E

Explanation:

The NSX Manager management plane communicates with the transport nodes by using APH Server over NSX-RPC/TCP through port 1234. CCP communicates with the transport nodes by using APH Server over NSX-RPC/TCP through port 1235.
Taken from NSX-T ICM 3.0 Lecture manual

Reveal Solution Next Question

QUESTION: 8

An NSX administrator is using ping to check connectivity between VM1 running on ESXi1 to VM2 running on ESXi2. The ping tests fails. The administrator knows the maximum transmission unit size on the physical switch is 1600.

Which command does the administrator use to check the VMware kernel ports for tunnel end point communication?

esxcli network diag ping -H <destination IP address>
vmkping ++netstack=geneve -d -s 1572 <destination IP address>
vmkping ++netstack=vxlan-d -s 1572 <destination IP address>
esxcli network diag ping -I vmk0 -H <destination IP address>

Answer(s): C

Reference:

https://kb.vmware.com/s/article/1003728

Reveal Solution Next Question

Free 2V0-41.20 Exam Braindumps (page: 2)

QUESTION: 5

QUESTION: 6

QUESTION: 7

Explanation:

QUESTION: 8

Reference: