CompTIA
Checkpoint
ISC
HP
Dell
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
Certiport
ISC2
All Vendors
  2. Home
  3. Exams
  4. Alcatel-Lucent
  5. 4A0-105

Free 4A0-105 Exam Braindumps (page: 24)

Page 23 of 49
PDF with 193 Questions

Click on the exhibit below.


Given the following configuration, which service type will VPLS 1 and VPLS 100 be displayed as with the "show service service-using" command?

  1. VPLS 1 will be displayed as mVPLS and VPLS 100 will be displayed as VPLS.
  2. VPLS 1 will be displayed as mVPLS and VPLS 100 will be displayed as uVPLS
  3. VPLS 1 will be displayed as VPLS and VPLS 100 will be displayed as VPLS.
  4. VPLS 1 will displayed VPLS and VPLS 100 will be displayed as uVPLS.

Answer(s): A



Click on the exhibit below.


If the device connected to PE-A in Metro A sends a frame to PE-A that requires replication within the VPLS which devices is PE-A responsible for replicating the frame to?

  1. PE-A must replicate the frame to all devices participating in the VPLS
  2. PE-A must replicate the frame to all PEs within Metro A
  3. PE-A must replicate the frame to all devices in the Metro A
  4. All of the above

Answer(s): B



What type of SDP cannot be configured in an l-VPLS?

  1. Mesh-sdp
  2. Spoke-sdp
  3. MPLS
  4. GRE

Answer(s): A



Which of the following describes the setting of the l-SID on the Alcatel-Lucent 7750 SR?

  1. The I-SID is set to 0 by default and is only used for interop purposes. The receiving PE uses the service label to determine the I-VPLS.
  2. There is no default value. The I-SID must always be explicitly configured
  3. The I-SID is set to the service-id, unless the service-id is larger than a 24 bit value. In this case the I-SID must be explicitly configured.
  4. The I-SID is always set to the service-id by default.

Answer(s): C






Post your Comments and Discuss Alcatel-Lucent 4A0-105 exam with other Community members:

4A0-105 Discussions & Posts