QUESTION: 33

Choose the two SAP identifiers that a Cross Connect ID (CCID) can bind to create a bi-directional Layer 2 and Layer 3 service cross connect. (Choose two.)

sap 1/1/9:100:200
sap 1/1/8:100:200
sap ccag-l.a:l00
sap ccag-2.a:100
sap ccag-1.b:100
sap ccag-2.b:200

Answer(s): C,E

Reveal Solution Next Question

Click on the exhibit

Given the diagram shown and the following information:
· Configured on the CSA1 router is an ePipe with redundant spoke Service Distribution Points (SDPs) · The spoke SDPs terminate on Internet Enhanced Services (IES) interfaces configured on each of the two remote Provider Edge (PE) routers.
Which statement correctly describes how the remote PEs signal Maximum Transmission Unit (MTU) values for the ePipe spoke terminations?

The remote PE routers signal the default IES service 1514 byte MTU to the CSA1 router
The remote PE routers signal the IES spoke SDP Virtual Circuit (VC)-MTU based on the SDP path MTU
The PE routers set the service MTUs to the lowest negotiated value
The remote PE routers must signal a VC-MTU equal to the ePipe service MTU plus the Ethernet header size

Answer(s): B

Reveal Solution Next Question

QUESTION: 35

Click on the exhibit

Given the configurations shown and the following information:
· Multilayer Switch (MLS) 1 and 2 host duplicate Virtual Private Routed Network (VPRN) services. · Configured on the interfaces L3_VLAN402 is Virtual Router ID (VRID) 1 Your customer states that if the master interface fails and recovers, they want traffic to remain on the VRID backup interface.
What must you change in the configuration shown to keep the VRID from moving traffic back to the master?

set a revert time value of infinity
configure no preempt in the VRID
set both interface priorities to the default
set MLS1 interface L3_VLAN402 to priority 255

Answer(s): B

Reveal Solution Next Question

QUESTION: 36

Click on the exhibit.

Given the diagram
On the MLS routers, you wish to configure a Management Virtual Private LAN Service (mVPLS) running Spanning Tree Protocol (STP) on behalf of VPLS 300.
What must you configure on the MLS routers? (Choose two.)

Configure mVPLS Service Access Points (SAPs) on the same access ports as used in the VPLS 300 service
Configure mVPLS SAPs with the same Virtual LAN (VLAN) tags as those used on the VPLS 300 SAPs
Turn up STP on each of the MLS1 and MLS2 VPLS 300 SAP physical access ports
Create a managed VLAN list on each mVPLS SAP for all protected VPLS 300 VLANs
Provision the mVPLS SAPs with unique VLAN tags within the VPLS 300 service context

Answer(s): A,D

Reveal Solution Next Question

Free 4A0-M01 Exam Braindumps

QUESTION: 33

QUESTION: 34

QUESTION: 35

QUESTION: 36