QUESTION: 53

Click on the exhibit

Given the configuration example shown:

The DS1 port shown will become a Structure Agnostic TDM over Packet (SAToP) Service Access Point (SAP) access port.
What must be configured on the DS1 port to allow it to carry all 24 TDM timeslots as a stream of consecutive octets?

Set encap-cem in the channel group
Set encap-type satop-t1 on the port
Set framing ds1-unframed on the port
Set the channel-group timeslots to 1-24

Answer(s): C

Reveal Solution Next Question

QUESTION: 54

Click on the exhibit

Given the configuration shown and the following information:
· The port configured as shown is used in a cPipe service Service Access Point (SAP) 1/2/1.1 · Each packet contains a 256 byte payload.
Based on the number of timeslots in each frame, what jitter buffer size, in milliseconds (ms), does the router set for this SAP?

5 ms
8 ms
16 ms
32 ms

Answer(s): A

Reveal Solution Next Question

QUESTION: 55

Click on the exhibit

Given the show results shown, and the following information:
· CSA1 originates a redundant ePipe service
· The remote PE Service Access Points (SAPs) are Multichassis-Link Aggregation Group (MC-LAG) members
What would cause the spoke SDP status 0x26?

Peer 192.0.2.1's ePipe SAP is in standby
The local node has deleted its label for spoke SDP 2:1
Peer 192.0.2.1's ePipe SAP port is operationally down
Spoke SDP 1:1 is the active redundant pseudowire

Answer(s): A

Reveal Solution Next Question

QUESTION: 56

Which statement correctly describes bi-directional Automatic Protection Switching (APS) as implemented in SROS?

The endpoints transmit the same data on the working and protect circuits
The endpoints send K2 keepalive bits on the working and protect circuits
A failure on the receive path causes both paths to switch to the protect circuit
Either the working or protection circuit can signal an APS switch

Answer(s): C

Reveal Solution Next Question

Free 4A0-M01 Exam Braindumps (page: 14)

QUESTION: 53

QUESTION: 54

QUESTION: 55

QUESTION: 56