QUESTION: 245

How does the dynamically-learned MAC address feature function?

The CAM table is empty until ingress traffic arrives at each port
Switches dynamically learn MAC addresses of each connecting CAM table.
The ports are restricted and learn up to a maximum of 10 dynamically-learned addresses
It requires a minimum number of secure MAC addresses to be filled dynamically

Answer(s): A

Show Answer Next Question

QUESTION: 246

When using Rapid PVST+, which command guarantees the switch is always the root bridge for VLAN 200?

spanning-tree vlan 200 priority 614440
spanning-tree vlan 200 priority 0
spanning-tree vlan 200 root primary
spanning-tree vlan 200 priority 38813258

Answer(s): B

Show Answer Next Question

QUESTION: 247

Refer to the exhibit. Which command must be executed for Gi1/1 on SW1 to passively become a trunk port if Gi1/1 on SW2 is configured in desirable or trunk mode?

switchport mode dynamic auto
switchport mode dot1-tunnel
switchport mode dynamic desirable
switchport mode trunk

Answer(s): A

Show Answer Next Question

QUESTION: 248

Refer to the exhibit. The entire contents or the MAC address table are shown. Sales-4 sends a data frame to Sales-1.

What does the switch do as it receives the frame from Sales-4?

Map the Layer 2 MAC address to the Layer 3 IP address and forward the frame.
Insert the source MAC address and port into the forwarding table and forward the frame to Sales-1.
Perform a lookup in the MAC address table and discard the frame due to a missing entry.
Flood the frame out of all ports except on the port where Sales-1 is connected.

Answer(s): B

Show Answer Next Question

Free Cisco® 200-301 Exam Braindumps (page: 63)

QUESTION: 245

QUESTION: 246

QUESTION: 247

QUESTION: 248

200-301 Exam Discussions & Posts