Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk
ServiceNow
All Vendors
  2. Home
  3. Exams
  4. Cisco
  5. 300-410

Cisco 300-410 Exam Questions
Implementing Cisco Enterprise Advanced Routing and Services (ENARSI) (Page 20 )

Updated On: 24-Feb-2026
Page 20 of 125
PDF with 640 Questions

Which command allows traffic to load-balance in an MPLS Layer 3 VPN configuration?

  1. multi-paths eibgp 2
  2. maximum-paths 2
  3. maximum-paths ibgp 2
  4. multi-paths 2

Answer(s): C


Reference:

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/5_x/nx-os/mpls/configuration/guide/mpls_cg/mp_vpn_multipath.html



Refer to the exhibit. After applying IPsec, the engineer observed that the DMVPN tunnel went down, and both spoke-to-spoke and hub were not establishing. Which two actions resolve the issue? (Choose two.)

  1. Change the mode from mode tunnel to mode transport on R3.
  2. Remove the crypto isakmp key cisco address 10.1.1.1 on R2 and R3.
  3. Configure the crypto isakmp key cisco address 192.1.1.1 on R2 and R3.
  4. Configure the crypto isakmp key cisco address 0.0.0.0 on R2 and R3.
  5. Change the mode from mode transport to mode tunnel on R2.

Answer(s): A,D



Which statement about route distinguishers in an MPLS network is true?

  1. Route distinguishers allow multiple instances of a routing table to coexist within the edge router.
  2. Route distinguishers are used for label bindings.
  3. Route distinguishers make a unique VPNv4 address across the MPLS network.
  4. Route distinguishers define which prefixes are imported and exported on the edge router.

Answer(s): C



Which statement about MPLS LDP router ID is true?

  1. If not configured, the operational physical interface is chosen as the router ID even if a loopback is configured.
  2. The loopback with the highest IP address is selected as the router ID.
  3. The MPLS LDP router ID must match the IGP router ID.
  4. The force keyword changes the router ID to the specified address without causing any impact.

Answer(s): B


Reference:

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_ldp/configuration/12-4m/mp-ldp-12-4m-book.pdf



Refer to the exhibit. Which interface configuration must be configured on the spoke A router to enable a dynamic DMVPN tunnel with the spoke B router?





Answer(s): B






Post your Comments and Discuss Cisco 300-410 exam dumps with other Community members:

Join the 300-410 Discussion