CompTIA
Checkpoint
ISC
HP
Dell
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
Certiport
ISC2
All Vendors
  2. Home
  3. Exams
  4. Cisco®
  5. 300-410

Free 300-410 Exam Braindumps (page: 59)

Page 23 of 156
PDF with 620 Questions

Refer to the exhibits. Phase-3 tunnels cannot be established between spoke-to-spoke in DMVPN. Which two commands are missing? (Choose two.)

  1. The ipnhrp redirect command is missing on the spoke routers.
  2. The ipnhrp shortcut command is missing on the spoke routers.
  3. The ipnhrp redirect command is missing on the hub router.
  4. The ipnhrp shortcut command is missing on the hub router.
  5. The ipnhrp map command is missing on the hub router.

Answer(s): B,C



Which protocol is used to determine the NBMA address on the other end of a tunnel when mGRE is used?

  1. NHRP
  2. IPsec
  3. MP-BGP
  4. OSPF

Answer(s): A



A DMVPN single hub topology is using IPsec + mGRE with OSPF.
What should be configured on the hub to ensure it will be the designated router?

  1. route map to set the metrics of learned routes to 110
  2. tunnel interface of the hub with ipnhrpospfdr
  3. OSPF priority to 0
  4. OSPF priority greater than 1

Answer(s): D



What are two purposes of using IPv4 and VPNv4 address-family configurations in a Layer 3 MPLS VPN? (Choose two.)

  1. RD is prepended to the IPv4 route to make it unique.
  2. The VPNv4 address consists of a 64-bit route distinguisher that is prepended to the IPv4 prefix.
  3. MP-BGP is used to allow overlapping IPv4 addresses between customers to advertise through the network.
  4. The IPv4 address is needed to tag the MPLS label.
  5. The VPNv4 address is used to advertise the MPLS VPN label.

Answer(s): A,E






Post your Comments and Discuss Cisco® 300-410 exam with other Community members:

300-410 Exam Discussions & Posts