CompTIA
Checkpoint
ISC
HP
Dell
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
Certiport
ISC2
All Vendors
  2. Home
  3. Exams
  4. Cisco®
  5. 300-430

Free 300-430 Exam Braindumps (page: 5)

Page 4 of 63
PDF with 282 Questions

An engineer must implement Cisco Identity-Based Networking Services at a remote site using ISE to dynamically assign groups of users to specific IP subnets. If the subnet assigned to a client is available at the remote site, then traffic must be offloaded locally, and subnets are unavailable at the remote site must be tunneled back to the WLC. Which feature meets these requirements?

  1. learn client IP address
  2. FlexConnect local authentication
  3. VLAN-based central switching
  4. central DHCP processing

Answer(s): C



An engineer must configure Cisco OEAPs for three executives. As soon as the NAT address is configured on the management interface, it is noticed that the WLC is not responding for APs that are trying to associate to the internal IP management address. Which command should be used to reconcile this?

  1. config flexconnect office-extend nat-ip-only disable
  2. config network ap-discovery nap-ip-only enable
  3. config flexconnect office-extend nat-ip-only enable
  4. config network ap-discovery nat-ip-only disable

Answer(s): D



An engineer is responsible for a wireless network for an enterprise. The enterprise has distributed offices around the globe, and all APs are configured in FlexConnect mode. The network must be configured to support 802.11r and CCKM. What needs to be implemented to accomplish this goal?

  1. Enable VLAN-based central switching.
  2. Enable FlexConnect local authentication.
  3. Enable FlexConnect local switching.
  4. Create FlexConnect groups.

Answer(s): D



A corporation has employees working from their homes. A wireless engineer must connect 1810 OEAP at remote teleworker locations. All configuration has been completed on the controller side, but the network readiness is pending. Which two configurations must be performed on the firewall to allow the AP to join the controller? (Choose two.)

  1. Block UDP ports 1812 and 1813 on the firewall.
  2. Enable NAT Address on the 5520 with an Internet-routable IP address.
  3. Configure a static IP on the OEAP 1810.
  4. Allow UDP ports 5246 and UDP port 5247 on the firewall.
  5. Allow UDP ports 12222 and 12223 on the firewall.

Answer(s): B,D


Reference:

https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-3/b_Cisco_OfficeExtend_Access_Point_.pdf






Post your Comments and Discuss Cisco® 300-430 exam with other Community members:

300-430 Discussions & Posts