Free 300-510 Exam Braindumps
Implementing Cisco Service Provider Advanced Routing Solutions (SPRI) Questions 86–90 (page: 19)

Updated On: 10-Feb-2026

Refer to the exhibit. Routers R1, R2, R3, and R4 have been configured to run OSPF, and router R5 is running EIGRP. Traffic from R1 to R5 is expected to pass via R4, but OSPF routing has calculated the best path R3. Which action corrects the problem?

  1. Reconfigure R1 in Area 0
  2. Configure R3 to use metric-type 1 with a higher metric than R4
  3. Configure R1 with a static route to the R5 networks and set R5 as the next hop
  4. Change the metric-type value on R3 to 2

Answer(s): D



Refer to the exhibit. A network engineer sets up a multihoming eBGP topology where multiple Autonomous Systems connect to ASN 64501. The engineer wants to block all the routes coming from ASN 64502 but allow all the others. For that purpose, the following AS Path prefix list is being used:

(config)#ip as-path access-list 10 deny _64502$

What must be fixed to achieve this result?

  1. The AS-PATH filter must be defined inside the route-map mode
  2. The statement must be modified with ip as-path access-list 1 deny_64502_
  3. The statement must be modified with ip as-path access-list 1 deny ^64502$
  4. At the end, ip as-path access-list 10 permit.* must be included

Answer(s): D



Refer to the exhibit. A network operator is working to deploy a Unified BGP design and allow it to be available only in selected markets and services in the future. The label allocation is not functioning as desired.


Which action will fix the issue?

  1. Reconfigure the route-policy ALL_LABELS to match all after the drop
  2. Remove the allocate-labels command
  3. Reconfigure the route-policy ALL_LABELS to pass
  4. Remove the route policy and only configure “allocate-label”

Answer(s): C



Refer to the exhibit. The green policy is designed with low delay, and the pink policy is designed with low cost. What is the next hop for node A on its way to node D, with the objective of achieving a low delay?

  1. 192.168.1.2
  2. 192.168.3.2
  3. 192.168.3.6
  4. 192.168.1.6

Answer(s): A



Which two differences should be considered when deciding whether to implement routing policies or route maps? (Choose two.)

  1. Sequences are added after implementing a route map, but routing policies must be reconfigured when change is needed
  2. Route maps are supported in Cisco IOS Software and routing policies are supported in Cisco IOS XR Software
  3. Route maps are implemented using hierarchical policies, but routing policies must be implemented sequentially
  4. Route maps require an explicit deny at the end of the sequence, but routing policies have an implicit deny at the end of the program
  5. Route policies require sequence numbers, but route maps are implemented without sequencing

Answer(s): A,B



Viewing page 19 of 49
Viewing questions 91 - 95 out of 269 questions


Post your Comments and Discuss Cisco 300-510 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!