Cisco®
Oracle
CompTIA
Checkpoint
ISC
EC-Council
EXIN
Fortinet
ITIL®
Juniper
Microsoft
VMware
Avaya
SAP
Google
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk®
All Vendors
  2. Home
  3. Exams
  4. Cisco®
  5. 350-401

Free Cisco® 350-401 Exam Braindumps (page: 58)

Page 53 of 268
PDF with 1067 Questions

Refer to the exhibit. A network engineer configures NAT on R1 and enters the show command to verify the configuration.
What does the output confirm?

  1. The first packet triggered NAT to add an entry to the NAT table.
  2. R1 is configured with NAT overload parameters.
  3. A Telnet session from 160.1.1.1 to 10.1.1.10 has been initiated.
  4. R1 is configured with PAT overload parameters.

Answer(s): A



Refer to the exhibit.
What is the cause of the log messages?

  1. OSPF area change
  2. MTU mismatch
  3. IP address mismatch
  4. hello packet mismatch

Answer(s): A



A network engineer configures BGP between R1 and R2. Both routers use BGP peer group CORP and are set up to use MD5 authentication. This message is logged to the console of router R1:
`May 5 39:85:55.469: %TCP-6-BADAUTH` Invalid MD5 digest from 10.10.10.1 (29832) to 10.120.10.1 (179) tebleid -0
Which two configurations allow a peering session to form between R1 and R2? (Choose two.)

  1. R1(config-router)#neighbor 10.10.10.1 peer-group CORP R1(config-router)#neighbor CORP password Cisco
  2. R2(config-router)#neighbor 10.120.10.1 peer-group CORP R2(config-router)#neighbor CORP password Cisco
  3. R2(config-router)#neighbor 10.10.10.1 peer-group CORP R2(config-router)#neighbor PEER password Cisco
  4. R1(config-router)#neighbor 10.120.10.1 peer-group CORP R1(config-router)#neighbor CORP password Cisco
  5. R2(config-router)#neighbor 10.10.10.1 peer-group CORP R2(config-router)#neighbor CORP password Cisco

Answer(s): A,B



Refer to the exhibit. An engineer implemented several configuration changes and receives the logging message on Switch1.
Which action should the engineer take to resolve this issue?

  1. Change Switch2 to switch port mode dynamic auto.
  2. Change the VTP domain to match on both switches.
  3. Change Switch1 to switch port mode dynamic auto.
  4. Change Switch1 to switch port mode dynamic desirable.

Answer(s): B



Viewing page 58 of 268
Viewing questions 229 - 232 out of 1067 questions



Post your Comments and Discuss Cisco® 350-401 exam prep with other Community members:

350-401 Exam Discussions & Posts