Free 201 Exam braindumps download (201 exam dumps Free)

QUESTION: 86

When using the setup utility to configure a redundant pair, you are asked to provide a "Failover Peer IP". Which address is this?

an address of the other system in its management network
an address of the other system in a redundant pair configuration
an address on the current system used to listen for fail‐over messages from the partner BIGIP
an address on the current system used to initiate mirroring and network fail‐over heartbeat messages

Answer(s): B

Show Answer Next Question

QUESTION: 87

Which two statements describe differences between the active and standby systems? (Choose two.)

Monitors are performed only by the active system.
Fail‐over triggers only cause changes on the active system.
Virtual server addresses are hosted only by the active system.
Configuration changes can only be made on the active system.
Floating self‐IP addresses are hosted only by the active system.

Answer(s): C,E

Show Answer Next Question

QUESTION: 88

Assuming other fail‐over settings are at their default state, what would occur if the fail‐over cable were to be disconnected for five seconds and then reconnected?

As long as network communication is not lost, no change will occur.
Nothing. Fail‐over due to loss of voltage will not occur if the voltage is lost for less than ten seconds.
When the cable is disconnected, both systems will become active. When the voltage is restored, unit two will revert to standby mode.
When the cable is disconnected, both systems will become active. When the voltage is restored, both systems will maintain active mode.

Answer(s): C

Show Answer Next Question

QUESTION: 89

Given that VLAN fail‐safe is enabled on the external VLAN and the network that the active BIGIP's external VLAN is connected to has failed, which statement is always true about the results.

The active system will note the failure in the HA table.
The active system will reboot and the standby system will go into active mode.
The active system will fail‐over and the standby system will go into active mode.
The active system will restart the traffic management module to eliminate the possibility that BIG‐IP is the cause for the network failure.

Answer(s): A

Show Answer Next Question

QUESTION: 90

Assuming there are open connections through an active system's virtual servers and a fail‐over occurs, by default, what happens to the connections.

All open connections are lost.
All open connections are maintained.
When persistence mirroring is enabled, open connections are maintained even if a fail‐over occurs.
Long‐lived connections such as Telnet and FTP are maintained, but short‐lived connections such as HTTP are lost.
All open connections are lost, but new connections are initiated by the newly active BIG‐IP, resulting in minimal client downtime.

Answer(s): A

Show Answer Next Question

Free 201 Exam Braindumps TMOS Administration Questions 86–90 (page: 19)

QUESTION: 86

QUESTION: 87

QUESTION: 88

QUESTION: 89

QUESTION: 90

Free 201 Exam Braindumps
TMOS Administration Questions 86–90 (page: 19)