Free HP0-P24 Exam Braindumps (page: 4)

Page 3 of 16

A system administrate wants to add disk3 as a mirrored boot disk Which step must the system administrator perform to allow the mirror copy to boot the server if the primary disk fails?

  1. mkboot --a "boot vmunix --q" /dev/rdisk/disk3
  2. mkboot a "boot vmunix --lq" /dev/disk/disk3
  3. mkboot --a "hoot vmunix --q" /dev/disk/disk3
  4. mkboot -a "boot vmunix -lq" /dev/rdisk/disk3

Answer(s): D



A system is going down just before a job scheduled with the at command starts. What will happen in this job?

  1. A question whether to start this job will be displayed on the console
  2. During system shutdown a warning will be displayed on the console
  3. The job will not be started
  4. The job will start during system startup.

Answer(s): D



What is the maximum amount of data that a make _tape_ recovery tape can hold when all applicable patches have been applied to an HP -UX server?

  1. Up to 2GB of data and only on a single tape regardless of the overall tape size
  2. Up to 8GB of data and only on a single tape regardless of the overall tape size
  3. As much as 2GB of data on a single tape hut if make _tape_ recovery is run in the foreground, it prompts for more tapes, if they are necessary, until all data is stored
  4. As much data as will fit on the tape but if make _tape_ recovery is run in the foreground, it prompts for more topes, if they are necessary

Answer(s): A



What is the purpose of an fsck command?

  1. To re-create a file system after a disk failure
  2. To repair a file system after patch Installation
  3. To check consistency of an unmounted file system
  4. To modify file system parameters

Answer(s): C


Reference:

http://www.computerhope.com/unix/fsck.htm






Post your Comments and Discuss HP HP0-P24 exam with other Community members: