Cisco®
CompTIA
Checkpoint
ISC
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk®
Scrum
All Vendors
  2. Home
  3. Exams
  4. HP
  5. HPE2-Z39

Free HPE2-Z39 Exam Braindumps (page: 4)

Page 3 of 17
PDF with 62 Questions

An Aruba Virtual Switching Framework (VSF) fabric has 10GbE interfaces assigned to its VSF link. The network administrator wants to change the link to use 40GbE interfaces. Which procedure follows the best practices and requirements to set up the VSF links?

  1. Create an LACP link aggregation on the 40GbE interfaces, and then add them to the VSF link.
  2. Shut down the standby member, remove the VSF link, and then re-create the link with only 40GbE interfaces.
  3. Create a second VSF link that uses the 40GbE interfaces, and then remove the first VSF link.
  4. Add the 40GbE interfaces to the VSF link, and then remove the 10GbE interfaces from the link.

Answer(s): A








A network administrator has set up OSPF to enable communications between subnets 10.1.4.0/24 and 10.1.8.0/24.
Swffch-4 is not receiving a route to 10.1.4.0/24.
What should the network administrator do to help fix this issue?

  1. Fix the router IDs on al switches so that they are valid.
  2. Enable OSPF on VLAN 4 on Switch-1.
  3. Configure Switch-1 with a better DR priority on VLANs 100 and 101.
  4. Verify that Switch-2 and Switch-3 are part of the backbone area.

Answer(s): B



What is one characteristic of a spanning tree edge port on an ArubaOS switch?

  1. The port link state does not affect the RSTP topology.
  2. The port connects to a switch that runs MSTP but in a different region.
  3. The port only forwards traffic in VLANs assigned to the instance 0 (IST).
  4. The port ignores incoming BPDUs

Answer(s): B



A network administrator enters this command on an ArubaOS switch:
Switch(config) # trunk 1,2 trk1
What is required for the switch to combine both interfaces in a link aggregation?

  1. that the interfaces are up
  2. that the interfaces are aggregated while in a shutdown state
  3. that the interfaces are up and connect to interfaces that support active mode LACP
  4. that the interfaces are up and have LACP enabled on them

Answer(s): B






Post your Comments and Discuss HP HPE2-Z39 exam with other Community members: