QUESTION: 1

Refer to the exhibit.

Aruba CX 6300 switch has routes in three different VRFs as per the example above. The user needs to leak routes between VRF Secure and VRF Dev. and also between VRF default and VRF Dev The customer Is not able to establish routing between directly connected networks 10.100.50.0/24 and 10.102.26.0/24 Which statement is true regarding the routing troubleshooting?

Multi-protocol BGP routing needs to be defined for route leaking
Route Distinguisher needs to be set to 1 for default VRF.
Route leaking is supported between non-default VRFs only
Route leaking between default and non-default VRFs is supported with Aruba CX 8400.

Answer(s): A

Reveal Solution Next Question

QUESTION: 2

The ArubaOS-CX switch requires plain-text authentication with OSPF.
The third-party switch should be configured with MD5 authentication
The ArubaOS-CX switch does not expect authentication with OSPF.
The third-party switch should be configured with key chain authentication

Answer(s): D

Reveal Solution Next Question

QUESTION: 3

When applying me following access-Iist to an ArubaOS-CX 6300 switch:

How does this ACL behave on the selected switch? (Select two.)

The mp traffic to MANAGEMENT-SERVERS group is logged to me event logs
The tftp traffic to MANAGEMENT-SERVERS group is not logged to the event logs.
The snmp-trap traffic to MANAGEMENT-SERVERS is logged to the event togs.
The denied tcp traffic to the MANAGEMENT-SERVERS group is logged to event logs.
The denied tcp traffic to the MANAGEMENT-SERVERS group is not logged to event logs

Answer(s): B,E

Reveal Solution Next Question

QUESTION: 4

The customer is considering Implemented the following VSX configuration that will host an Aruba mobility cluster servicing 9000 dual stack employee devices. The client's default gateways will be hosted on the VSX stack. The customer is seeking advice about how to ensure ArubaOS-CX VSX best practices have been applied.

What advice can you offer the customer? (Select two)

The ISL Bandwidth should be upgraded
Agg-1 and Agg-2's hardware forwarding table profile should be changed to "L3-agg''.
The -system-mac' of Agg-1 should be changed to an unused address from the unicast private address range
The vsx linkup-delay timer is unnecessarily high; it should be reduced to prevent excessive delay of packet forwarding when a VSX peer joins an existing master.
The Keepalive interface should be changed to interface LAG2 so there is redundancy through the mobility cluster.
The keepalive subnet is misconfigured, it has an inappropriate address on Agg-1.

Answer(s): B,F

Reveal Solution Next Question

Free HPE6-A69 Exam Braindumps (page: 1)

Pass your Aruba Certified Switching Expert Written Exam exam with these free Actual Questions and Answers

QUESTION: 1

QUESTION: 2

QUESTION: 3

QUESTION: 4