QUESTION: 5

(Scenarios may contain multiple errors which may or may not Impact the solution > Refer to the exhibit.

An engineer has attempted to configure two pairs of switches in the referenced configuration it is required to implement VSX keep-alive at the aggregation layer. The ports of the ArubaOS-CS 8325 switches used for Agg01 and Agg02 are populated as follows:

The configuration of switch AGG01 includes:

VSX keep-alive is not working.
Which modification should you make lo resolve the error condition?

Edit interface 1/1/48, adding the command "vpn-instance KA"
Modify the Interface lag 2 command, removing "multi-chassis"
Modify the Keepalive peer 192.168.20.2 source 192 168.20.1 command, adding "vrf KA"
Edit the vsx-sync command, adding "keep-alive"

Answer(s): B

Reveal Solution Next Question

QUESTION: 6

(Scenarios may contain multiple errors which may or may not impact the solution ) Refer to the exhibit.

An engineer has attempted to configure two pairs of switches in the referenced configuration It is required to implement VSX at the aggregation layer
The pons of the ArubaOS-CX 8325 switches used for Agg01 and Agg02 are populated as follows:

The configuration of switch AGG01 includes

The VSX cluster is not forming.
Which modification should you make to resolve the error condition?

Modify the system interface-group 4 speed tOg command change "25g" to "10g"
Modify the keepalive peer 192.168 20.2 source 192 168.20 1 command, changing "vrf KA" to "vrf mgmt"
Edit the vsx-sync command, adding "keep-alive"
Modify the vsx definition, changing "inter-switch-link lag 2" to" inter-switch-link lag 256"

Answer(s): A

Reveal Solution Next Question

QUESTION: 7

(Scenarios may contain multiple errors which may or may not impact the solution) Refer to the Exhibit.

An engineer has attempted to configure two pairs of switches m the referenced configuration it Is required to implement
Multi-Chassis Link Aggregation for each pair of switches

The ports of the Aruba 8325 switches used for Agg01 and Agg02 are populated as follows

The configuration includes:

There is an error message stating "mismatched group speed" What should you add to the configuration to correct the error?

"system Interface-group 1 speed I0g"
"allow-unsupported-transceiver
"speed 10-full" under interfaces 1/1/12 and 1/1/13
"speed 40-full" under interfaces 1/1/49 and 1/1/50

Answer(s): C

Reveal Solution Next Question

QUESTION: 8

An administrator is utilizing the orchestration capabilities of NetEdit.
What are the two plan types that can be created'' (Select two.)
Configuration management plan

Firmware plan
Firmware plan
Deployment plan
Configuration plan

Answer(s): A,B

Reveal Solution Next Question

Free HPE6-A69 Exam Braindumps (page: 2)

QUESTION: 5

QUESTION: 6

QUESTION: 7

QUESTION: 8