Free HPE6-A75 Exam Braindumps (page: 4)

Page 3 of 16

An administrator creates service-based policies for AirGroup on the Mobility Master (MM). The administrator can define location-based policy limits based on which information?

  1. AP names, AP groups, controller names, and controller groups
  2. AP Fully Qualified Location Names (FQLNs) and controller Fully Qualified Domain Names (FQDNs)
  3. AP names, AP groups, and AP Fully Qualified Location Names (FQLNs)
  4. Controller names, controller groups, and controller Fully Qualified Domain Names (FQDNs)

Answer(s): C



A network administrator can set the OSPF metric-type on an AOS-Switch to Type 1 or Type 2. What is the difference?

  1. A Type 2 metric marks external routes that can be advertised in NSSAs, while a Type 1 metric marks external routes that can only be advertised in normal areas.
  2. A Type 2 metric assigns cost 1 to a 100 Gbps link, while a Type 1 metric assigns cost 1 to all links of 100 Mbps or higher.
  3. A Type 2 metric is assigned to multiple external routes that are aggregated together, while a Type 1 metric does not permit external route aggregation.
  4. A Type 2 metric stays the same as the external route is advertised, while a Type 1 metric increments with internal OSPF link costs.

Answer(s): D



Which protocol do Mobility Controllers (MCs) use to detect a failed Mobility Master (MM)?

  1. VRRP
  2. SNMP
  3. PAPI
  4. IPSec

Answer(s): B



A company requires AOS-Switches at the campus core. The switches:

Will act as the default gateways for several campus VLANs Must provide redundancy for their services and tolerate the loss of a link or an entire switch
Must recover from the failure of one of the switches within a second or less

VRRP and MSTP are proposed to meet these requirements. What is an issue with this proposal?

  1. VRRP provides redundancy against lost links but not a failed switch.
  2. VRRP provides routing redundancy but not default gateway redundancy.
  3. VRRP does not interoperate with MSTP.
  4. VRRP takes longer than a second to fail over.

Answer(s): D






Post your Comments and Discuss HP HPE6-A75 exam with other Community members:

HPE6-A75 Discussions & Posts