Free HP HPE7-A08 Exam Braindumps (page: 2)

Refer to the partial exhibit from an HPE Aruba Networking CX 8325:



A new port 1/1/44 needs to be configured to connect to a 29301, which has the following configuration:



Which configuration would be used?





Answer(s): A



OSPF peering is configured between HPE Aruba Networking CX 6300 switches utilizing BFD. You've made this configuration on switch B, while switch A is in the default configuration:



Which BFD Tx/Rx interval values will switch A use for the show bfd session?

  1. Switch A show BFD sessions using 500ms
  2. Switch A show BFD sessions using 6000ms
  3. Switch A show BFD sessions using 2000ms
  4. Switch A show BFD sessions using 300ms

Answer(s): C



You have applied the following OSPF configuration but are seeing the output from the command below.
What is the reason for this?

  1. A loopback interface hasn't been configured on Agg-2
  2. OSPF interfaces are passive by default
  3. A different OSPF process ID is used on each switch
  4. A Layer-3 interface has not been associated with a VRF

Answer(s): D



You need to run a packet capture on a CX switch and be able to view the full output on a remote device in real-time.
What is the best way to do this?

  1. Configure a mirror session using ERSPAN to a computer running Wireshark
  2. Inspect the summary of the packets in real time on the switch using tcpdump
  3. Configure a mirror session with another port on the switch as the destination
  4. Configure a mirror session to the CPU, use tshark to capture it to a PCAP file

Answer(s): A



When configuring a multicast solution on HPE Aruba Networking CX switches, what needs to be configured on the access switch to enable efficient traffic flow?

  1. PIM on VLAN
  2. IGMP-snooping on VLAN
  3. IGMP on VLAN
  4. IGMP-snooping on SVI

Answer(s): B



Viewing page 2 of 16
Viewing questions 6 - 10 out of 75 questions



Post your Comments and Discuss HP HPE7-A08 exam prep with other Community members:

HPE7-A08 Exam Discussions & Posts