support@Free-Braindumps.com
Register Login
Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
CrowdStrike
Anthropic
All Vendors
  1. Home
  2. Exams
  3. HP
  4. HPE7-A08

Free HPE7-A08 Exam Braindumps
HPE Network Switching Professional Questions 16–20 (page: 5)

Updated On: 10-Feb-2026
Page 5 of 16
PDF with 172 Questions

You recently made a configuration change on a switch, and shortly afterward, you noticed a spike in CPU utilization in the NAE dashboard. You are concerned that the high CPU could be affecting users.
What should you do to restore service as quickly as possible?

  1. Reboot the switch.
  2. Revert the change.
  3. Disable debug logging.
  4. Pause NAE monitoring.

Answer(s): B



You are implementing HPE Aruba Networking CX switches in a hotel environment.
Which feature would allow you to use a single subnet for the wired guests, allowing them to utilize only default gateway services and communicate with each other in a conference room but not elsewhere?

  1. By assigning the guest users in the conference room to an isolated VLAN and the gateway to a primary VLAN.
  2. By assigning the guest users in the conference room to a community VLAN and the gateway to a primary VLAN.
  3. By assigning the guest users in the conference room to a primary VLAN and the gateway to an isolated VLAN.
  4. By assigning the guest users in the conference room to an isolated VLAN and the gateway to a community VLAN.

Answer(s): B



You have added a switch with existing configuration to an existing group in HPE Aruba Networking Central, but the configuration is not synchronizing.
What could cause this?

  1. The switch is still pending authorization on the organization settings page.
  2. Only switches with factory default config can be added to a group with existing config.
  3. Configuration auto-commit has been disabled for the group in HPE Aruba Networking Central.
  4. The switch is configured in a VSX pair, which HPE Aruba Networking Central does not support.

Answer(s): B



Refer to the exhibit:



A senior network architect has created the configuration above. You are implementing the setup in Building A and C. The actual fiber distance between the building locations is 200m / 656ft utilizing OM4 cabling.
What needs to be changed in the configuration based on the actual environmental conditions to complete the installation and 7 other CX 6300 VSF stack connections in the future?

  1. Replace the 25GR optics with 10SR
  2. Replace the 25GR optics with 25LR
  3. Replace the 25GR optics with 10LR
  4. Replace the 25GR optics with 25SR

Answer(s): D



You are remotely connected to an HPE Aruba Networking CX 6200F switch using SSH to change the Control Plane ACL, allowing only defined subnets to access the switch.
Which AOS-CX command allows you to roll back your change if the ACL change is wrongly formed and you can no longer log in to the switch?

  1. Use the checkpoint commit command after you commit the change.
  2. Use the checkpoint auto command before you commit the change.
  3. Use the checkpoint auto command after you commit the change.
  4. Use the checkpoint commit command before you commit the change.

Answer(s): B



  PDF
Viewing page 5 of 16
Viewing questions 21 - 25 out of 172 questions


Post your Comments and Discuss HP HPE7-A08 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!