support@Free-Braindumps.com
Register Login
Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
CrowdStrike
Anthropic
All Vendors
  1. Home
  2. Exams
  3. HP
  4. HPE7-A08

Free HPE7-A08 Exam Braindumps
HPE Network Switching Professional Questions 26–30 (page: 7)

Updated On: 10-Feb-2026
Page 7 of 16
PDF with 172 Questions

You are configuring OSPF between two CX switches but cannot see any neighbors. Based on the output, how would you fix the problem?

  1. Remove the max-metric router-lsa on-startup to allow faster formation of adjacency.
  2. Configure ip ospf network broadcast on the VLAN 182 interface.
  3. Configure no ip ospf cost 100 on the VLAN 182 interface.
  4. Configure no passive-interface vlan182 on the switch.

Answer(s): D



What are valid NAE agent actions? (Select two)

  1. Run a CLI command
  2. Generate an SNMP trap
  3. Generate a local system log
  4. Start/stop a packet capture
  5. Create a new TAC case

Answer(s): A,C



Refer to the partial exhibit from HPE Aruba Networking CX 8325:



If a new CX 8325 is to be deployed, which switch profile should be used to provide gateway and routing services?

  1. L3-core profile should be selected instead of the factory default
  2. Spine profile should be used, which is the factory default
  3. Leaf profile should be selected instead of the factory default
  4. The L3-apg profile should be selected instead of using the factory default

Answer(s): D



You have attempted to configure DHCP snooping, but it is not working as expected. Based on the output below, what do you need to configure?

  1. Configure an authorized DHCP server
  2. Configure a DHCP trusted interface
  3. Enable dhcpv4-snooping on VLAN 100
  4. Enable dhcpv4-snooping globally

Answer(s): D



How does an HPE Aruba Networking CX VSX solution make the hardware replacement of a single switch a non-disruptive operation for Layer 2 configurations?

  1. By the utilization of any of the four reserved ranges as system-MAC addresses.
  2. By the VSX-sync option for synchronization of the system-MAC.
  3. By entering the primary switch system-MAC on the secondary switch.
  4. By allowing the system MAC in the ServiceOS to be changed to the original system MAC.

Answer(s): D



  PDF
Viewing page 7 of 16
Viewing questions 31 - 35 out of 172 questions


Post your Comments and Discuss HP HPE7-A08 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!