QUESTION: 145

If PoE is enabled on the switch, you can no longer access legacy devices on these interfaces.

True
False

Answer(s): B

QUESTION: 146

Each AC device needs to specify the source IP address of the AC to establish a CAPWAP tunnel with the AP. One AC can specify up to two WLAN source IP addresses.

True
False

Answer(s): B

Reveal Solution Next Question

According to the following configuration example, the following statement is correct.

[AC] dhcp enable
[AC] interface VLANif100
[AC-VLANif100] ip address 10.1.100.1 24 [AC-VLANif100] dhcp select interface [AC-VLANif100] quit

The DHCP service is enabled by default in the global mode, so the dhcp enable can be configured. The
dhcp select interface command enables the DHCP client function on the interface of VLAN 100.
If VLAN 100 is a user VLAN, the gateway is 10.1.100.1 and the mask is 255.255.255.0 after the user receives the address.
If VLAN 100 is the management VLAN where the AP is located, the option 43 field in the DHCP message received by the AP should be 10.1.100.1.

Answer(s): C

Reveal Solution Next Question