Which are the correct procedures of Mesh route establishment in pro-active mode? (Multiple Choice)

1. The MP periodically broadcasts PREQ.
2. The MPs/MPPs receiving the PREQ reply with unicast PREP.
3. The route and return route are established between two points.
1. The MPP periodically broadcasts RANN.
2. The MP receiving the RANN sends a unicast PREQ to the MPP.
3. The MPP replies with a PREP.
4. The route is established between MP and MPP.
1. The MPP periodically broadcasts RANN.
2. The MP receiving the RANN sends a unicast PREP to the MPP.
3. The route is established between MP and MPP.
1. The MPP periodically broadcasts PREQ.
2. The MP receiving the PREQ sends a unicast PREP to the MPP.
3. The route is established between MP and MPP.

Answer(s): B,D

Which of the following methods is recommended to differentiate enterprise employees from guests in wireless admission control scenarios?

Answer(s): C

Which of the following statements about a Fresnel zone is TRUE?

Answer(s): C

Which of the following statements about the N+l backup networking shown in the figure are TRUE? (Multiple Choice)

Standby AC3 must be on the same Layer 2 network as active AC1 and active AC2.
Basic WLAN service configurations on standby AC3 must be the same as those on active AC1 and active AC2 to ensure that APs can obtain the correct configuration after an active/standby switchover of AGs.
AP-specific priorities can be configured on active and standby ACs respectively so that APs can select the corresponding active AC based on the priority configurations on ACs.
Corresponding MAC address whitelists can be configured on active ACs to ensure that APs select the correct active AC and go online on the AC.

Answer(s): B,C,D

Free H12-321 Exam Braindumps (page: 23)