Free H12-811 Exam Braindumps
HCIA-Datacom V1.0 Questions 594–617 (page: 70)

Updated On: 31-Jan-2026

The output information of the routing table of a certain router is shown in the figure. Which of the following statements is correct? () (Multiple Choice Questions)
<R1>display ip routing-table
Route Flags: R-relay, D-download to fib

  1. The NextHop for this router to reach 10.0.2.2 is 10.0.12.2
  2. The NextHop for this router to reach 10.0.0.1 is 10.0.12.2
  3. The NextHop for this router to reach 10.0.2.2 is 10.0.21.2
  4. The NextHop for this router to reach 10.0.0.1 is 10.0.21.2

Answer(s): B,C



Which of the following descriptions about the 0SPF area is correct ()*

  1. All networks should be declared in zone 0
  2. The number of the backbone area cannot be 2
  3. Before configuring the OSPF area, you must configure an IP address for the loopback interface of the router
  4. The number range of the area is from 0.0.0.0 to 255.255.255.255

Answer(s): B,D



Through sR (Segment Routing), an explicit path can be easily defined. The nodes in the network only need to maintain the SegmentRouting information to cope with the real-time and rapid development of the business. What are the following characteristics of Segment Routing?

  1. Extending the existing protocol (eg IGP) can make the existing network better and smoothly evolve
  2. SR (Segment Routing) adopts IP forwarding, no extra dimensioning is required-a label forwarding table
  3. Source routing technology is used to provide the ability to quickly exchange text between the network and upper-layer applications
  4. At the same time, it supports the centralized control mode of the controller and the distributed control mode of the transponder, providing a balance between centralized control and distributed control

Answer(s): A,C,D



The output information of a certain router is shown in the figure. Which of the following statements are correct? () (Multiple Choice Questions)

  1. The Router ID of the router is 10.0.1.1
  2. This router is DR
  3. The interface address of this router is 10.0.12.2
  4. The Router ID of the router is 10.0.2.2.

Answer(s): B,C,D



As shown in the figure below, assuming that the other configurations of the switch are kept in the default state, which port of the following switch will become the designated port? () (Multiple Choice Questions)

  1. G0/0/1 of SWB
  2. SWC's G0/0/2
  3. SWA's G0/0/3
  4. SWC's G0/0/1

Answer(s): A,C



Viewing page 70 of 147
Viewing questions 346 - 350 out of 872 questions


Post your Comments and Discuss Huawei H12-811 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!