Free H12-811 Exam Braindumps
HCIA-Datacom V1.0 Questions 603–607 (page: 72)

Updated On: 31-Jan-2026

The controller is the core component of SDN. The controller is connected to the device through the southbound interface. The following is missing from the controller southbound agreement? ()

  1. SNMP
  2. PCEP
  3. OpenFlow
  4. NETCONF

Answer(s): A,C



After the two routers are configured with 0SPF, the administrator configures the command on RTA. The following description is correct ()

  1. The neighbor relationship between the two routers will be down
  2. The neighbor relationship between the two routers will not be affected
  3. RTA. Will no longer send OSPF packets
  4. RTA. will continue to receive and analyze and process OSPF packets sent by RTB.

Answer(s): B,C,D



Which of the following statements about the default route are correct? ()

  1. If the destination address of the message cannot match any other routing entries in the routing table, the router will forward the message according to the default route
  2. There must be a default route in the routing table of any router
  3. The default route can only be manually configured by the administrator
  4. In the routing table, the default route appears in the form of a route to the network 0.0.0.0 (the mask is also 0.0.0.0)

Answer(s): A,D



The function of the 0SPF hel1o message is ()

  1. Neighbor discovery
  2. Maintain neighbor relations
  3. Update LSA. Information
  4. Synchronize the LSDB of the router

Answer(s): A,B



The output information of the sub-interface of a certain router's aggregation port 1 is shown in the figure. Based on this information, which of the following statements is correct? ( )

[Router A] display Interface Eth-Trunk 1.100Eth-Trunk1.100 current state UP Line protocol current state UP Last line protocol up time 2019-03-04 10:22:40 UTC.-08:00 Description: HUAWEI, ARSeries, Eth-Trunk1.100 Interface Route Port, Hash arithmetiC.:According to SIP-XOR-DIP, Maximal BW:2G.Current BW:2G, The Maximum Transmit Unit is 1500 Internet Address is 10.0.12.2/24 IP Sending Frames'Format is PKTFIT ETENT 2, Hardwareaddress 1s 00e0-fc3b-2015 Current system time:2019-03-04 10:24:29-08:00 Last 300 seconds input rate0 bits/sec.0 packets/sec Last 300 seconds output rate 0 bits /seC.0 packets/sec Realtime 0 seconds inputrate 0 bits/seC.0 packets/sec Realtime 0 seconds output rate 0 bits/seC.0 packets/sec Input: 6 packets, 574 bytes,
Output: 7 packets, 638 bytes, Input bandwidth utilization 0% Output bandwidth utilization 0% PortName Status Weight GigabitEthernet0/0/1 UP 1 GigabitEthernet0/0/2 UP 1
The Number of Ports in Trunk:2 The Number of UP Ports in Trunk:2*

  1. Two links exist on the aggregated port
  2. The P address of the sub-interface of the aggregate port is 10.0.12.2/24
  3. The sub-interface number of the aggregate port is 100
  4. The sub-interface of the aggregate port carries VLAN TAG100 when forwarding data frames

Answer(s): A,B,C



Viewing page 72 of 147
Viewing questions 356 - 360 out of 872 questions


Post your Comments and Discuss Huawei H12-811 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!