Free JN0-348 Exam Braindumps (page: 11)

Page 10 of 24

How many bytes of overhead are added to a packet traversing a GRE tunnel?

  1. 20
  2. 24
  3. 12
  4. 16

Answer(s): B



You added a new ESXi host connected to port ge-0/0/1. One of the VMs configured with VLAN 10 is not reachable from any other device on the switch. To troubleshoot, you decide to verify if the VM’s MAC address is learned properly under VLAN 10. Which command would you use in this scenario?

  1. show ethernet-switching table vlan-id 10
  2. show interfaces ge-0/0/1 detail
  3. show vlans 10
  4. monitor interface ge-0/0/1

Answer(s): A



You are adding a new EX4300 member switch to your existing EX4300 Virtual Chassis. However, the new member is not running the same Junos version as the other members.
By default, what is the expected behavior in this scenario?

  1. the Virtual Chassis will transition into a split brain situation between the existing master Routing Engine and the switch running the different version.
  2. The new switch will automatically pull the correct version from the master Routing Engine and perform the necessary upgrade.
  3. The new switch will be assigned a member ID and then placed in an inactive state.
  4. The new switch is not recognized by the Virtual Chassis.

Answer(s): C



What are the three possible port states when using RSTP? (Choose three.)

  1. forwarding
  2. learning
  3. discarding
  4. listening
  5. tagging

Answer(s): A,B,C






Post your Comments and Discuss Juniper JN0-348 exam with other Community members:

JN0-348 Discussions & Posts