Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk
ServiceNow
All Vendors
  2. Home
  3. Exams
  4. Network Appliance
  5. NS0-159

Network Appliance NS0-159 Exam
NetApp Certified Data Administrator, ONTAP (Page 5 )

Updated On: 1-Feb-2026
Page 3 of 19
PDF with 89 Questions

You have a new cluster and must create a LIF on a port that uses LACP and VLAN.
What is the correct order of network tasks that are required before you create the LIF?

  1. ifgroup -> VLAN -> add port to broadcast domain
  2. VLAN -> ifgroup -> add port to broadcast domain
  3. add port to broadcast domain ­ ifgroup -> VLAN
  4. add port to broadcast domain -> VLAN -> ifgroup

Answer(s): A



What are three advantages of configuring network subnets? (Choose three.)

  1. The default gateway is automatically added to the SVM.
  2. The DNS zone is automatically set on the NAS LIF.
  3. The subnet mask is automatically set on the NAS LIF.
  4. The flow control is automatically set on the port.
  5. The IP address is automatically set on the NAS LIF.

Answer(s): A,B,E



Click the Exhibit button.



While troubleshooting performance issues, you notice that only one port in the NetApp interface group a0a is actively sending or receiving data.

Referring to the exhibit, what should you do to ensure that both ports in the interface group are actively used?

  1. Change the distribution function to ip.
  2. Verify that the network switch has flow-control enabled.
  3. Change the interface group mode to multimode_lacp.
  4. Verify that the physical cabling is properly connected to ensure a network link.

Answer(s): C



You have an 8-node cluster and need to test a ping to all cluster interconnect ports between all of the eight in one command.
Which advanced command would accomplish this task?

  1. cluster ping-cluster
  2. network ping6
  3. network ping
  4. cluster peer ping

Answer(s): A



Which two actions would you take to create a FlexGroup for the SVM vsO in an NFSv3 environment? (Choose two.)

  1. Use the volume flexgroup deploy command.
  2. Enable the -v3-64bit-identifiers parameter.
  3. Enable the -v3-f sid-change parameter.
  4. Use the aggregate create command.

Answer(s): A,B



Viewing page 5 of 19
Viewing questions 21 - 25 out of 89 questions



Post your Comments and Discuss Network Appliance NS0-159 exam prep with other Community members:

Join the NS0-159 Discussion