support@Free-Braindumps.com
Register Login
Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
CrowdStrike
Anthropic
All Vendors
  1. Home
  2. Exams
  3. Network Appliance
  4. NS0-520

Free NS0-520 Exam Braindumps
NetApp Certified Implementation Engineer - SAN Specialist ONTAP Questions 106–110 (page: 23)

Updated On: 9-Feb-2026
Page 23 of 48
PDF with 234 Questions

Exhibit.



The VMware ESX host discovers only two of four paths to a LUN on a new ONTAP cluster. Referring to the exhibit, which statement Is correct?

  1. The fabric zoning configuration does not allow access to the target LlFs.
  2. The igroup does not contain the. WWPN of one initiator.
  3. The fabric name server is disabled.
  4. The initiator HBA is not connected to the fabric.

Answer(s): D



A customer wants to use both Cisco FC and FCoE switches in their ONTAP environment. According to NetApp best practices, what are two requirements in this scenario? (Choose two.)

  1. You must use single initiator zoning.
  2. You must create interface groups to isolate FC and FCoE LIFs.
  3. You must create a trunk with multiple virtual LANs.
  4. You must not have more than one target UF for the same physical port in a single fabric zone.

Answer(s): A,D



You are provisioning a LUN using an ISCSI initiator on an ESX host. You disable Ethernet flow control for all ports but are experiencing
Performance issues.
In this scenario, which two actions would improve the performance issue? (Choose two.)

  1. Set the MTU settings 1500 for optimal performance.
  2. Dedicate your ports to ISCSI traffic.
  3. Enable jumbo frames across the entire data path.
  4. Confirm that your host .mil storage polls are connected to a different network.

Answer(s): B,C



Exhibit.



You are adding a boot LUN for a new server. The server uses FCP attached through a CN

  1. The ONTAP cluster is also attached to the same fabric by way of UTA2. You configure the zoning for the fabric as shown in the exhibit. You discover that the server cannot see its boot LUN.
    What is the problem with your zoning configuration?
  2. The zone set must have the same name as the zone.
  3. The zone was not activated.
  4. The zone used a wrong zone I
  5. The WWPN for the NetApp LIF is incorrect.

Answer(s): D



An administrator needs to connect a new VMware 6.5 cluster to an ONTAP cluster for iSCSl connectivity.
Which two steps would accomplish this task? (Choose two.)

  1. Enable iSCSl adapters on the ESXi hosts.
  2. Install the Virtual Storage Console for VMware vSphere.
  3. Configure zoning for the HBAs and the ONTAP data LIFs.
  4. Configure ALUA on the ONTAP SVM.

Answer(s): A,D



  PDF
Viewing page 23 of 48
Viewing questions 111 - 115 out of 234 questions


Post your Comments and Discuss Network Appliance NS0-520 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!