QUESTION: 9

End users are complaining of high latency when accessing an ONTAP 9 luster.
Which command helps you to determine whether there is a storage component that is contributing to this problem?

qos statistics performance show
qos statistics latency show
sysstat -c 30 -M 1
wafltop show -v -cpu -I 10 -c 5-n 6

Answer(s): A

Reveal Solution Next Question

Click the exhibit button.

You have just cabled a new shelf to a FAS8200. Running the system node run -node * sysconfig - a command indicates that multipath HA is configured. However, after running Config Advisor, you receive an error that your cabling is incorrect.

As indicated in the exhibit, which two actions will correct the cabling? (Choose two.)

Move the 0b SAS connection on the bottom controller to 0d on the bottom controller.
Move the 0b SAS connection on the top controller to 0d on the top controller.
Move the 0b SAS connection on the top controller to 0d on the bottom controller.
Move the 0b SAS connection on the bottom controller to 0d on the top controller.

Answer(s): A,B

Reveal Solution Next Question

QUESTION: 11

Click the exhibit button.

A volume move operation has been initiated to move a volume named MirrScr from one aggregate to another. The operation failed with the error that is shown in the exhibit.

In this scenario, which statement is correct?

Manually trigger the cutover process in order to restart the job.
The volume move cannot be completed at this time because of high use in this node.
There are too many snapshots on the source volume.
Cancel and restart the volume move operation.

Answer(s): A

Reveal Solution Next Question

QUESTION: 12

Click the exhibit button.

You are troubleshooting a system in which the customer reports that aggregates on Stack 6c/12b are having slow response tomes from system NETAPP1CLUS-02.

Referring to the exhibit, which two statements are correct? (Choose two.)

The aggregates have only one PHY running at six gigabits per second on 6c.
PHY 2 is running at six gigabits per second; on system NETAPP1CLUS-02, reseat IOM6 Module A on Shelf 10.
The shelf module firmware is downrev; on system NETAPP1CLUS-02, replace IOM6 Module A on Shelf 10.
The aggregates have only PHY at six gigabits per second on 12b.

Answer(s): A,C

Reveal Solution Next Question

Free NS0-592 Exam Braindumps (page: 3)

QUESTION: 9

QUESTION: 10

QUESTION: 11

QUESTION: 12