QUESTION: 13

Your customer has mounted an NFS SVM from a Linux client unci performance is very poor. The customer is certain that they have jumbo frames enabled. They have verified an MTU of 9000 on both the Linux client and the broadcast domain on the NetApp ONTAP 9.8 cluster.

Referring to the exhibit, which ONTAP command will help isolate a possible MTU mismatch?

Answer(s): B

Reveal Solution Next Question

QUESTION: 14

You have a customer complaining of long build times from their NetApp ONTAP-based datastores. They provided you packet traces from the controller and client. Analysis of these traces shows an average service response time of 1 ms. QoS output confirms the same. The client traces are reporting an average of 15 ms in the same time period.
In this situation, what would be your next step?

The cluster is responding slowly and requires further investigation using performance archives.
The client that reports high latency should be investigated.
The cluster interconnects should be investigated.
A sync core should be triggered.

Answer(s): B

Reveal Solution Next Question

QUESTION: 15

Your customer wants to access a LUN on a FAS 8300 system from a VMware ESXi server through the FC protocol. They already created a new SVM, volume. LUN, and igroup for this purpose. The customer reports that the server's FC HBA port Is online, but the LUN does not show up.

Referring to the exhibit, what is the reason for this problem?

The FC service has not been configured on the SVM.
The zoning on the FC switches Is Incorrect.
The LUN Is not mapped to the correct SCSI ID.
The esxserver igroup contains incorrect IQNs.

Answer(s): C

Reveal Solution Next Question

QUESTION: 16

You recently discovered the error message shown below in your ONTAP logs.

What should be your first action to correct this Issue?

Power cycle all the disk storage shelves that contain drives of the aggregate with the my_data_vol volume.
Determine the root cause behind the inconsistency before attempting any recovery procedure.
Use the storage takeover command on the storage controller that contains my_data_vol.
Use the wafliron command against my_data_vol to solve the inconsistency on the volume.

Answer(s): A

Reveal Solution Next Question

Free NS0-593 Exam Braindumps (page: 4)

QUESTION: 13

QUESTION: 14

QUESTION: 15

QUESTION: 16