Free 4A0-100 Exam Braindumps (page: 30)

Page 29 of 89

What is the function of the Routing Table Manager?

  1. Based on the metrics of the routing protocol, find the best path to the destination network and install it in the routing table.
  2. Provide a CLI interface to allow the operator to configure the dynamic routing protocol on the router.
  3. Based on the routing protocol preference values, chose the route with the lowest preference and install it in the routing table.
  4. Provide a CLI interface to allow the network operator to install static routes in the routing table.

Answer(s): C



Which of the following is characteristic of a static route?

  1. Responds in real time to network failures.
  2. Can only be used for routing within an autonomous system.
  3. Uses a hop-count metric to determine the best route to a network.
  4. Explicitly defines the next hop based on operator input.

Answer(s): D



Which of the following describes a static default route?

  1. An entry included in the default configuration of the router that is used if no dynamic routing protocols or static routes are configured.
  2. A wildcard entry used when the destination network is not specifically defined in the routing table.
  3. An entry selected based on the route that has the least cost to the destination (path with the most physical bandwidth)
  4. An entry used by the routing protocol when it is unable to calculate the best route to the destination.

Answer(s): B



Based on the network diagram (click on the exhibit), what is the command to use on R1 to setup a static route to the network on CR1

  1. config router static-route 192.168.2.0/24 next-hop 10.2.3.2
  2. config router static-route 10.2.3.1 next-hop 192.168.2.0
  3. config router static-route 192.168.2.0/24 next-hop 10.2.3.1
  4. config router static-route 10.2.3.2 next-hop 192.168.2.0

Answer(s): C






Post your Comments and Discuss Nokia 4A0-100 exam with other Community members:

4A0-100 Discussions & Posts