Free 4A0-103 Exam Braindumps
Nokia Multiprotocol Label Switching Questions 116–120 (page: 25)

Updated On: 9-Feb-2026

Two directly connected routers set different interface Hello timeout values. Router R1 uses 15 seconds, while router R2 uses 30 seconds. Which of the following best describes the LDP adjacency?

  1. The adjacency forms with the lower timeout value.
  2. The adjacency forms with the higher timeout value.
  3. The adjacency is in init state.
  4. The adjacency times out after 30 seconds.

Answer(s): A



An Alcatel-Lucent 7750 SR enabled with LDP has multiple equal cost paths to a given FEC. After ECMP is enabled, which of the following is FALSE?

  1. The router has new entries added for the given FEC in its LIB.
  2. The router has new entries added for the given FEC in its FI
  3. The router generates a single label for the given FEC and advertises it to all its peers,
  4. The router has multiple LSP tunnels for the given FEC.

Answer(s): A



Which of the following about the RSVP-TE Hello protocol is FALSE?

  1. The Hello protocol can speed up convergence without reducing refresh time.
  2. Hello messages are sent after at least one RSVP session is active on the interface.
  3. An interface with multiple RSVP sessions sends Hello messages for each session.
  4. An RSVP neighbor is declared down if Hello messages are not received within the Hello timeout.

Answer(s): C



Which of the following describes how a router sets the destination IP address for an RSVP RESV message?

  1. It sets the address to the system address of the head-end router.
  2. It sets the address to the next upstream hop from the ERO.
  3. It sets the address to the next upstream hop from the PSB.
  4. It sets the address to the next upstream hop from the RRO.

Answer(s): C



Which of the following about RSVP-TE on an Alcatel-Lucent 7750 SR is TRUE?

  1. Label bindings are distributed to other routers when explicitly requested.
  2. Label bindings are distributed to all neighbors including non-downstream routers.
  3. Label bindings are distributed if labels have not been received from downstream routers.
  4. All labels received from downstream neighbors are stored in the LIB.

Answer(s): A



Viewing page 25 of 51
Viewing questions 121 - 125 out of 256 questions


Post your Comments and Discuss Nokia 4A0-103 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!