QUESTION: 389

Click on the exhibit.

If router R2 re-distributes the IS-IS route 192.168.3.0/24 into OSPF, router R3 will receive two routes to 192.168.3.0/24. Assume that all IS-IS routers are L1/L2 capable and are in the same area.
Which of the following is TRUE?

Router R3 will install the OSPF route in its routing table.
Router R3 will install the IS-IS route in its routing table
Router R3 will install an OSPF route and an IS-IS route in its routing table.
There is not enough information to answer the question.

Answer(s): B

Reveal Solution Next Question

QUESTION: 390

Which default LDP parameter are you able to change with CLI?

Label space mode
Label retention
Control mode
Keepalive factor

Answer(s): D

Reveal Solution Next Question

QUESTION: 391

An OSPF adjacency is stuck in the exstart state. What is the most likely cause?

The MTU does not match on both interfaces.
OSPF is not enabled on one of the routers.
The router ID is the same on both routers.
An OSPF Hello has not been received from the neighbor.
The interfaces are configured as point-to-point on one side and broadcast on the other.

Answer(s): A

Reveal Solution Next Question

QUESTION: 392

Click on the exhibit.

Given the output shown, which router is the ASBR in this network?

10.10.10.2
10.10.10.3
10.10.10.4
10.10.10.6
There is no ASBR configured in the network.

Answer(s): E

Reveal Solution Next Question

Free 4A0-C01 Exam Braindumps (page: 98)

QUESTION: 389

QUESTION: 390

QUESTION: 391

QUESTION: 392