4A0-C01 Practice Test & Exam Dumps
Nokia NRS II Composite Exam Questions 291–295 (page: 60)

Updated On: 9-Feb-2026

When multiple routing protocols offer a route for the same prefix, what part of the router is in charge of deciding which route to make active?

  1. The routing information base (RIB).
  2. The routing table manager (RTM).
  3. The equal cost multipath configuration (ECMP).
  4. The forwarding information base (FIB).
  5. The link state database (LSDB).

Answer(s): B



An OSPF backbone area contains Type 5 LSAs. If an attached area receives only Summary LSAs from the backbone area, what type of area is the attached area?

  1. Normal
  2. Stub
  3. Totally stubby
  4. Totally NSSA

Answer(s): B



Click on the exhibit.

Which of the following best describes the format of data traffic sent to the server as it exits from the PC?

  1. The destination IP address will be the system IP address of router R1 and the destination MAC address will be the MAC address of the router R1 port connected to the PC.
  2. The destination IP address will be the IP address of the router R1 port connected to the PC and the destination MAC address will be the MAC address of the router R1 port connected to the PC.
  3. The destination IP address will be the IP address of the server and the destination MAC address will be the MAC address of the server.
  4. The destination IP address will be the IP address of the server and the destination MAC address will be the MAC address of the router R1 port connected to the PC.

Answer(s): D



Click on the exhibit button below.

LSP 1's link between routers R3 and R6 has failed, and the RESV state at router R3 has timed out. Which of the following actions will router R3 initiate?

  1. Send a Path Tear message towards router R6.
  2. Send a Path Tear message towards router R1.
  3. Send a Resv Tear message toward router R6.
  4. Send a Resv Tear message toward router R1.

Answer(s): D



Which of the following statements regarding LSP path configuration are true? (Choose three)

  1. The path must include at least one hop.
  2. The path may be used multiple times in a single LSP.
  3. The path may comprise loose hop entries only.
  4. The path must define the LSP's tail end.
  5. The path may be used for multiple LSPs.

Answer(s): C,E



Viewing page 60 of 170
Viewing questions 296 - 300 out of 852 questions


Post your Comments and Discuss Nokia 4A0-C01 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!