CompTIA
Checkpoint
ISC
HP
Dell
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
Certiport
ISC2
All Vendors
  2. Home
  3. Exams
  4. Nokia
  5. 4A0-C01

Free 4A0-C01 Exam Braindumps (page: 70)

Page 69 of 212
PDF with 852 Questions

Click on the exhibit.

In the topology shown, router R1 is an ASBR configured to export external routes to OSPF. Assuming that there are no stub networks, which of the following statements regarding Type 5 LSA generation is TRUE?

  1. Router R1 generates a Type 5 LSA that is flooded to area 1 only.
  2. Router R1 generates a Type 5 LSA that is flooded to areas 1 and 0. Router R6 generates a Type 5 LSA that is flooded to area 2.
  3. Router R1 generates a Type 5 LSA that is flooded to areas 0.1, and 2.
  4. Router R3 generates a Type 5 LSA that is flooded to areas 0 and 2
  5. Type 5 LSAs are not generated in this network topology.

Answer(s): C



Click on the exhibit.

Assume that OSPFv3 is properly configured on all routers and that router R4 advertises its system prefix into Area 0. Which of the following best describes how router R5 learns router R4's IPv6 system prefix?

  1. With a Router LSA originated by router R1.
  2. With a Router LSA originated by router R5.
  3. With a Router LSA originated by router R4.
  4. With an Inter-Area Prefix LSA originated by router R1.
  5. With an Inter-Area Prefix LSA originated by router R5.
  6. With an Inter-Area Prefix LSA originated by router R4.

Answer(s): D



What is the goal of MPLS Traffic Engineering?

  1. To establish additional LSPs across the network
  2. To allow ECMP to occur across an MPLS network
  3. To enable the implementation of services
  4. To utilize paths other than the lowest cost path

Answer(s): D



Click on the exhibit button below.

Under which condition might the peer LDP ID 10.10.10.2:0 entry show state "Nonexistent"?

  1. When the interface to the peer router is down.
  2. When router R1 has no route to the peer address 10.10.10.2.
  3. When the adjacency between the two routers fails.
  4. When the targeted session is not yet configured.

Answer(s): B






Post your Comments and Discuss Nokia 4A0-C01 exam with other Community members:

4A0-C01 Exam Discussions & Posts