QUESTION: 45

A customer has a Nutanix cluster with 10Gb connectivity via switch fabric extenders. The administrator receives NCC health check errors of latency greater than 200ms.
Which action should the administrator take to resolve the NCC errors?

Replace the switch fabric extenders with 10G line rate switches
Upgrade NCC and increase the CVM memory by 4Gb
Add 2 additional 10G uplinks from the switch fabric extenders per node
Upgrade NCC and increase the vCPU of the CVM

Answer(s): A

Explanation:

Reference:

https://portal.nutanix.com/page/documents/details?targetId=System-Specs-G6-Single-Node:set-block-connect-c.html

Reveal Solution Next Question

QUESTION: 46

For several days, an administrator notices the following alerts:

•CVM NIC Speed Low Warning Alerts
•Warning Alerts of CVM NIC not performing at optimal speed
•CVM is disconnected from the network Critical Alert
•Network Visualization page shows excessive dropped packets on CVM/Host

Which steps should be taken to determine which problem should be addressed first?

• Access the Hardware Page to verify resources are available
• Analyze ail CVM Speed Alerts in the Alerts/Events page
• Analyze output for the network and interface properties and connectivity issues
• Verify Host/CVM connectivity on the Network Visualization page
• Use to verify the bridge and bond configuration
• Review alerts/events page for the CVM disconnected error
• Review Alerts page for NIC speed alerts and alert timing
• Analyze the genesis.out log file for process failures
• Assess the NIC properties in the Network Visualization > Host Properties page
• Restart networking services on the CVM
• Determine the current configuration of the affected CVM via output
• Access the Alerts/Events page for the CVM network connection failures

Answer(s): B

Reference:

https://portal.nutanix.com/page/documents/kbs/details?targetId=kA00e000000CuaDCAS

Reveal Solution Next Question

QUESTION: 47

Refer to the exhibit.

An administrator configures Active Directory authentication as shown in the exhibit. Upon finishing setup, users are not able to log in. What configuration change should be made to fix this issue?

Change leaps to https
Change the Directory URL to use an IP rather than a name
Change the plct from 389 to 636
D Change the Domain to use an IP rather than a name

Answer(s): C

Reference:

https://portal.nutanix.com/page/documents/details?targetId=Prism-Central-Guide-Prism-v510:mul-security-authentication-pc-t.html

Reveal Solution Next Question

QUESTION: 48

In a Nutanix cluster, a Protection Domain contains 50 entities that are replicated to a remote Single Node Replication Target.

The current schedule configuration is as follows:
•Repeat every 6 hours
•Local Retention Policy 1
•Remote Retention Policy 8
•Starting time 12 am

At 8 am on Monday, the administrator discovers that a protected VM is corrupted. The latest good state was Sunday 2 pm. The administrator needs to maintain current protection. Which strategy should the administrator use to meet these requirements?

From the Remote site, activate the Protection Domain, then re-protect the entity.
From the Remote site, restore the VM from the local snapshot by selecting the correct snapshot
From the local site, retrieve the correct remote snapshot, then restore the VM locally.
From the local site, restore the VM from the local snapshot by selecting the correct snapshot.

Answer(s): C

Reveal Solution Next Question

Free Nutanix Certified Master - Multicloud Infrastructure (NCM-MCI) 5.20 Exam Braindumps (page: 12)

QUESTION: 45

Explanation:

Reference:

QUESTION: 46

Reference:

QUESTION: 47

Reference:

QUESTION: 48